Home Blog  
Education / Training Hammerli Storm Elite: Part 3 – Back to the range

Hammerli Storm Elite: Part 3 – Back to the range

by B.B. Pelletier

Part 1
Part 2

I had a great day at the range. Shot two rifles for record and tested two other products – one of which you’ll read about tomorrow!

What looks like the next day to you was actually a separation of nearly a week since I last shot the Hammerli Storm Elite, so a lot of things had to be remembered. One was the lousy too-heavy trigger on this beast. It feels like it may lighten up but I don’t have the thousand shots to invest. However, I think some of you may want to do it, based on what I saw.

When we last talked…
The short-range sight-in you read about yesterday saved me bundles of time at the big range. The rifle was already on target and I knew one good pellet, the Crosman Premier 7.9-grain, as well as five that weren’t worth trying again. Also, the barrel was clean, so I was ready to shoot in no time.

At the range
The day was perfect. No wind and clear skies. I had an additional “helper” I will tell you about tomorrow that really aided me in getting the groups I got. I set the target out at 30 yards, and you will remember that the gun is scoped with a Leapers Bug Buster 2 6×32 scope.

First shots
The scope was right on for elevation but shooting a bit to the left, so I dialed it in and proceeded to shoot some nice groups under an inch. My heartbeat was moving the reticle about a quarter to half an inch. I tell you that because a spring gun has to be floated on the palm of your hand to limit the biological input from your body. The recoil and vibration of the gun at firing is attenuated by your body, which alters the direction of recoil. This is what makes spring guns so difficult to shoot, compared to pneumatics and gas guns.

Coupled with that, the Storm Elite is a breakbarrel which is also sensitive about WHERE it is held. I had determined that a point just ahead of the balance point worked for this rifle, so no time was lost looking for another sweet spot.

Then, I discovered a fantastic device that tightened the groups by about 40 percent more than I was holding! You’ll hear about it tomorrow. But the bottom line is this – the Storm Elite can shoot 3/4″ groups at 30 yards all day long with good pellets. Yes, the Premiers are good, but so are Gamo Match wadcutters! I shot a group of four into 0.631″. The fifth shot was a called flier (the rifle slipped as the shot went off) and opened the group to more than two inches, but I feel confident telling you it was a bad shot and not the rifle’s fault. I would have shot more of these but time was heavy because I had lots of guns to test.

storm-tgt1-30-web
Five Premiers at 30 yards went into this 0.755″ group. The Euro is for scale for our European readers.

storm-tgt2-30-web
Four Gamo Match wadcutters made this 0.631″ group. The fifth shot was a called flier and opened the group to over 2″.

The rifle does kick some and vibrates briefly, but on the whole it is a well-behaved spring gun. If they could just do something about that horrible, heavy trigger!

Bottom line
The Storm Elite is a keeper. Bfore you ask, that makes the regular Storm a keeper, as well, because finish is all that separates the two.

author avatar
Tom Gaylord (B.B. Pelletier)
Tom Gaylord, also known as B.B. Pelletier, provides expert insights to airgunners all over the world on behalf of Pyramyd AIR. He has earned the title The Godfather of Airguns™ for his contributions to the industry, spending many years with AirForce Airguns and starting magazines dedicated to the sport such as Airgun Illustrated.

21 thoughts on “Hammerli Storm Elite: Part 3 – Back to the range”

  1. B.B. I’m trying to learn everything I can about my air rifle (Beeman imported RX-1) made by weihrauch, model- HW90. I bought this in .177 cal. and want to order a .25 cal. barrel. I am told the power plant is the same for all calibers (?) is this true? I know this isn’t the right place to post a question but couldn’t find where to do it. Thanks.

  2. BB, this whole trigger issue is driving me nuts. So many solid guns have lousy triggers. What I’m wondering is, why does a gun like the IZH-61 have such a nice, light trigger, but an otherwise good gun like the Sheridan Silver Streak has such a heavy pull? Is it the difference in power, the difference in powerplant, or just a business decision?

  3. B.B.,

    Im planning on puying an RWS 48, i saw at http://www.dianaairguns.com a catalogue that showed a RWS M-48A, which has an adjustable cheekpiece and some other diferent features. Do you know if they still make them?, if yes, where in the internet can I find one?

    Secondly, I have heard that the RWS 48 comes with a plastic trigger and i dont like the idea at all, specially because it is a high quality rifle and it couldnt have cost much. Is there any way to change the plastic trigger for a steel one?

    Finally, How usefull would a peep sight be in this rifle for shooting from 30 – 80 feet or even up to 50 yards?, would I need to change the front sight post for a hooded target-style or would it work well with the standard one, what peep sight do you recomend?

    Thank You

    Alex

  4. peep sight + 50 yards? NO NO NO!

    I saw a groundhog at 50 yards and did not even take aim. Thats a long way. If i had my condor with its 32x scope or my theoben with a 6x scope. I could have leveled it without thinking about it. You need some mag.

    -sumo

  5. I was surprised to see in this review that you were using wadcutters at such a long distance. About how far out do you generally recomend shooting a wadcutter before you begin to lose accuracy?

  6. B.B.

    You sure have me wondering about that device also. I hope you say its a tackdrive shooting bag. I ordered one the other day and it showed up at my door yesterday morning. I read somewhere on the internet that a person was having good luck with it. I didn’t have great luck with my mtm predator shooting rest , but then its on a tote thats not big enough.

    I had a vision last night that it would be great to have a shooting rest that didn’t change your your point of impact when shooting with out the rest. It could have different density of interchangeable foam. lol It sounds like a pipe dream.

    Back to reality I have a Gamo trigger I need to take out and put Richards insert in.

  7. Alex,
    i dont like peep sights in general because they are not as effective as a scope. A gun is =ly as acurate with a peep sight, scope, red dot, laser on it. Its just as acurate with a unsighted scope as it is with a sighted scope. Its just a hell of a lot easier to shoot a gun accuratly with a sighted in scope. If you have to have a peep sight thats ok but it wont be much good past 20 yards.

    What type of shooting will you be doing? Hunting, i hope not with a peep sight. the 48 is a great gun far past 20 yards. Its not a match.

  8. BB – they DID do something about the trigger – it’s called the “Razor”.

    It seems that Norica has 2 triggers, the cheap one they use on
    the Storm (and the Beeman GH1050) and a better one that’s used on the Razor and GS1000.

    The AR1000 you liked so much is a cloned Norica with the better trigger.

    The Beeman SS1000’s come in 2 flavors – the cheaper ones clone the Hammerli Storm/GH1050 action and trigger, the better ones are essentially the same as the AR1000.

    I also believe that the basic powerplants are the same in all the above rifles (bore, stroke, spring).

  9. Yup. No doubt about it.

    What kills me is the fact that the better trigger can’t be THAT much more expensive to make – heck, the entire AR1000 (with the nice trigger) can be had for under $90… and its trigger is absolutely no worse than the original Spanish version (as on my Beeman S1). So why not have the Chinese make the trigger groups – and stick ’em on ALL the rifles, even the Spansish made ones?

    Then the “upscale” versions of this rifle wouldn’t really be much different (except for the gingerbread stuff) – and they might have a harder time commanding stiffer prices for ’em.

    Just my guess, anyway…

Leave a Reply to CyberSkin Cancel reply

Buy With Confidence

  • Free Shipping

    Get FREE shipping on qualifying orders! Any order $150+ with a shipping address in the contiguous US will receive the option for free ground shipping on items sold & shipped by Pyramyd AIR during checkout. Certain restrictions apply.

    Free shipping may not be combined with a coupon unless stated otherwise.

    View Shipping Info

  • Shipping Time Frame

    We work hard to get all orders placed by 12 pm EST out the door within 24 hours on weekdays because we know how excited you are to receive your order. Weekends and holiday shipping times will vary.

    During busy holidays, we step our efforts to ship all orders as fast as possible, but you may experience an additional 1-2 day delay before your order ships. This may also happen if you change your order during processing.

    View Shipping Times

  • Shipping Restrictions

    It's important to know that due to state and local laws, there are certain restrictions for various products. It's up to you to research and comply with the laws in your state, county, and city. If you live in a state or city where air guns are treated as firearms you may be able to take advantage of our FFL special program.

    U.S. federal law requires that all airsoft guns are sold with a 1/4-inch blaze orange muzzle or an orange flash hider to avoid the guns being mistaken for firearms.

    View Shipping Restrictions

  • Expert Service and Repair

    Get the most out of your equipment when you work with the expert technicians at Pyramyd AIR. With over 25 years of combined experience, we offer a range of comprehensive in-house services tailored to kickstart your next adventure.

    If you're picking up a new air gun, our team can test and tune the equipment before it leaves the warehouse. We can even set up an optic or other equipment so you can get out shooting without the hassle. For bowhunters, our certified master bow technicians provide services such as assembly, optics zeroing, and full equipment setup, which can maximize the potential of your purchase.

    By leveraging our expertise and precision, we ensure that your equipment is finely tuned to meet your specific needs and get you ready for your outdoor pursuits. So look out for our services when shopping for something new, and let our experts help you get the most from your outdoor adventures.

    View Service Info

  • Warranty Info

    Shop and purchase with confidence knowing that all of our air guns (except airsoft) are protected by a minimum 1-year manufacturer's warranty from the date of purchase unless otherwise noted on the product page.

    A warranty is provided by each manufacturer to ensure that your product is free of defect in both materials and workmanship.

    View Warranty Details

  • Exchanges / Refunds

    Didn't get what you wanted or have a problem? We understand that sometimes things aren't right and our team is serious about resolving these issues quickly. We can often help you fix small to medium issues over the phone or email.

    If you need to return an item please read our return policy.

    Learn About Returns

Get FREE shipping on qualifying orders! Any order $150+ with a shipping address in the contiguous US will receive the option for free ground shipping on items sold & shipped by Pyramyd AIR during checkout. Certain restrictions apply.

Free shipping may not be combined with a coupon unless stated otherwise.

View Shipping Info

Text JOIN to 91256 and get $10 OFF Your Next $50+ Order!

* By providing your number above, you agree to receive recurring autodialed marketing text msgs (e.g. cart reminders) to the mobile number used at opt-in from Pyramyd AIR on 91256. Reply with birthday MM/DD/YYYY to verify legal age of 18+ in order to receive texts. Consent is not a condition of purchase. Msg frequency may vary. Msg & data rates may apply. Reply HELP for help and STOP to cancel. See Terms and Conditions & Privacy Policy.