| Weight: 6.20 lbs Overall Length: 39.20" Capacity: 300 round(s) Item # 180921 |
| DPMS M16-A3 Reloading DPMS M16-A3 Charging the Battery DPMS M16-A3 Loading the Battery DPMS M16-A3 Safety Operation DPMS M16-A3 Firing DPMS M16-A3 Hop Up DPMS M16-A3 If Gun Does Not Fire Caution |
![]() The magazine release button is located on the right side of the gun body. With one hand, hold the gun by the grip and use that same index finger to push the magazine release button in. Use your other hand to pull the magazine out of the gun. Take care not to drop the magazine. | ![]() After the magazine is removed, open the BB feeding port, located on the top of the magazine and pour BBs in until it is full. Close the BB feeding port and insert the magazine back into the gun, push up until you hear a "click". |
![]() After you hear the click, wind the BB Feeding Dial on the bottom of the magazine to engage the BBs in the inner chamber. You can also use the included winder to wind the inner spring. Your gun is now loaded and should be handled with additional care. | |
| back to top | |
| Plug the white end of the battery to the white end of the charger (matching the square pin to the square pin and the circle pin to the circle pin), plug the charger in a power outlet to charge. To estimate the charge time, take the miliamp hour (mAh) of the battery, i.e. 1500, devide by the miliamp (mA) output of the charger, i.e. 200, to equate optimum charge time of a drained or discharged battery. i.e. 1500/200 = 7.5 hours. Never overcharge the battery as it can cause an explosion, leakage or irreversible damage. | |
| back to top | |
![]() Open the battery compartment in the stock of the gun by pulling the tab down of the battery compartment cover. The cover will fold down. | ![]() Take the battery and match up the white end from the battery to the white end of the plug located inside the battery compartment (matching the square pin to the square pin and the circle pin to the circle pin.) |
![]() The battery will fit snug in the compartment. Push the cover up until the cover locks into place. | |
| back to top | |
![]() Put the "Safety On" by turning the lever to the "Safe" position. | |
| back to top |
![]() With the gun pointed in a safe direction, take "Safety Off" by turning the lever to the "Semi" or "Auto" position. Setting the switch to semi (semi-automatic) will fire one BB for each trigger pull. Setting the switch to auto will fire BBs automatically as long as the trigger is held. Squeeze the trigger when you are ready to fire. | |
| back to top |
![]() The adjustable hop up enables you to put a back stpin on the BB to increase range. To adjust the hop up, use your left hand and pull back and hold the charging handle. | ![]() This opens the bolt. |
![]() You will see the hop up dial inside the bolt. Adjusting the hop up dial clockwise will increase the hop up and adjusting the hop up dial counter clockwise will decrease the hop up. Be careful, if you put too much hop up on the BB, the BB will hook upwards. NOTE: Increasing Hop Up does not result in a higher FPS. | |
| back to top | |
| Step 1: Wind the Magazine Dial on the bottom of the magazine. Step 2: Turn the Hop Up all the way off. Step 3: Fire the gun in a safe direction, treating the gun as if it is still loaded. If ammunition still does not fire, do the following: Step 1: Put "Safety On" by turning the lever to the "Safe" position. Remove the magazine. Step 2: Clear the barrel by running a cleaning rod through from the muzzle end. NEVER point the muzzle toward yourself or anyone else. Be careful not to damage the bolt tip by pushing the rod too hard. Step 3: Point in a safe direction, take "Safety Off", and then test fire. Step 4: Repeat operation steps. | |
| back to top |
| CAUTION DISASSEMBLING (TAKING APART) THIS SOFTAIR PRODUCT VOIDS ALL WARRANTY. PRODUCT MUST BE RETURNED IN ITS ORIGINAL PACKAGING. FEDERAL LAW PROHIBITS ALTERING OR REMOVING THE ORANGE MARKING OR PAINTING OVER THE TRANSPARENT PART OF THIS PRODUCT. Do NOT use 6mm paintballs with this softair. Shooting paintballs with this unit will result in jamming and will void warranty. Warning |
| back to top |