Shopping Cart Items

    CheckoutSubtotal:
    does not include shipping and tax

    FREE USA GROUND SHIPPING
    Continental USA. On orders $150 and up
    Cannot be combined with coupons.

    ADJUSTMENT

    OPERATING | MAINTENANCE | ADJUSTING

    TRIGGER ADJUSTMENT

     

    THE TRIGGER IS TWO STAGE WITH ADJUSTMENTS ON BOTH STAGES. BE AWARE THAT ADJUSTMENT TO ONE SCREW WILL AFFECT THE ADJUSTMENT OF THE OTHER AND THE TRIGGER WILL ONLY WORK PROPERLY IF THERE IS THE CORRECT

    BALANCE BETWEEN THE TWO. IF YOU HAVE NO EXPERIENCE IN ADJUSTING TWO STAGE TRIGGERS

    SEEK GUIDANCE OR LEAVE THE TRIGGER AS SET BY THE FACTORY. INCORRECT ADJUSTMENT CAN MAKE

    THE RIFLE UNSAFE.

     

    THERE ARE THREE ADJUSTING SCREWS.

    SCREW (A) THE WEIGHT OF PULL SCREW. THIS IS UNDER THE REAR OF THE TRIGGER GUARD AND THE GUARD MUST BE REMOVED TO MAKE ADJUSTMENTS. CLOCKWISE MOVEMENT INCREASE THE WEIGHT.

     

    SCREW (B) & (C) ARE IN THE TRIGGER BLADE ITSELF.

     

    SCREW(B) ADJUSTS THE EXACT PULL-OFF POINT. CLOCKWISE DECREASES THE PULL-OFF

    POINT.

    SCREW(C) ADJUSTS THE LENGTH OF FIRST STAGE TRAVEL, AGAIN CLOCKWISE DE�CREASES THE LENGTH OF FIRST STAGE TRAVEL.

    REMEMBER THAT SMALL ADJUSTMENTS WILL MAKE A NOTICEABLE CHANGE TO THE OPERATION OF THE TRIGGER. ONLY MAKE 1/4 TURN ADJUSTMENTS AT A TIME AND TEST FIRE THE RIFLE BEFORE MAKING FURTHER ADJUSTMENTS. JOT DOWN ALL ADJUSTMENTS ON A PEICE OF PAPER SO THAT YOU CAN RETRACE YOUR STEPS IF NECESSARY.

    NOTE!: IF THE TRIGGER GUARD IS REMOVED AND THEN REPLACED, THE REAR SCREW (TX460) MUST BE TIGHTENED BEFORE THE FRONT SCREW (TX440). DO NOT OVER-TIGHTEN THE FRONT SCREW. THIS SCREW PULLS THE ACTION INTO THE STOCK AND ONLY NEEDS TO BE TIGHT ENOUGH TO STOP MOVEMENT WITHIN THE STOCK.

     

    Shop at Gun Mall
    Back to Top