does not include shipping and tax
|Power Range||66 yards|
|Caliber/Ammunition||6mm Round BBs|
|Magazine capacity||550 BBs|
|Total length||2.30 feet (.701m), 3.05 feet (.930m) with stock extended|
|Weight||6.8 lbs (3.084 kg)|
|Accuracy||50/25 (You can hit a quarter from 50 feet with .20g bbs)|
|Velocity||351 fps with 0.2g BBs|
|Shooting System||Spin up system|
NOTICE FOR USE
Dissasembling (taking apart) this airsoft product voids all warranty. Product must be returned in its original packaging.
Federal law prohibits altering or removing the orange marking or painting over the transparent part of this product.
Do NOT use 6mm paintballs with this airsoft unit as this may result in jamming and will void warranty.
-Store the gun unloaded and do not look down the barrel (treat as if loaded).
-Never aim at a person, shoot fragile objects, or point at anything you do not wish to shoot.
-Keep finger off the trigger until ready to shoot and use eye protection
-Be careful to avoid rebounding.
-Keep out of reach of children.
-Only use .20 g and .25 g BBs
A) Release magazine by pushing on the lever (1) located in front of th trigger gauerd and slide the magazine out of the receptacle (2).
H) Access the Hop Up system by pullin on the charging handle (1). Move the cursor to adjust firing system (2). Adjust according to weight of BBs used.
B) To load the magazine, open the tab on top (1) and fill the compartment with recommended BBs (about 300 BBs) into compartment (2).
I) Adjust rear sight (Hop Up must be adjusted first) by moving the sliding part up or down (1). Release button is loacted on the left side of it (2).
C) Spin the wheel located at the bottom of the magazine anticlockwise for about 1 minute. Repeat operation every 150 shots.
J) To start shooting, aim at target, select (1) the desired firing mode (semi or full auto mode) and pull the trigger (2).
D) Insert magazine in receptacle. If you notice some dry firing during burst, spin the wheel again.
K) After you are done shooting remove the magazine and put the selector back in "SAFE" position. Make sure to remove all BBs from rifle and/or magazine before storage.
E) Push the release (1) as shown on the picture to open the reciever top (2).
L) Front sight can be adjusted in elevation.
F) Plug the charged battery to the connector (1) and slide it into compartment. Make sure to place the wires under the connector.
M) To fold or unfold the certical grip, press the release shown on the picture.
G) Push (1) and lock cover back in place (2) as shown in picture.
N) 1- Push the stock as shown to unfold.