Special tape inside the rings keeps your scope tight without excessive clamp pressure!
Roll over image to zoom in
Lifetime limited warranty
List Price $17.99 Save $6.04 (33%)
Earn 12 Bullseye Bucks
Create an online review and share your thoughts with other customers
Things I liked: These are the perfect height on my marauder. Seem to be good solid rings.
Things I would have changed: nothing
Things I liked: Solid build quality; they always just work with little fuss.
Things I would have changed: Can't think of anything that wouldn't increase their cost?
What others should know: Leapers/UTG are inexpensive, scope ring "Standard". No Whistles and Bells, but they just work.
Things I liked: Outstanding mount! Looks really nice and is super strong with super clamping force on the rail.
Things I would have changed: Nothing.
What others should know: Be sure you consider the height. For example this medium is ideal for most things imo, and I much prefer the lower stance over a high mount. So far I have not needed a high for any gun, but I limit my scopes to 40AO and 44 like the UTG/Leapers with side parallax. Example; with a UTG 3-12x44AO (SCP3-U312AOIEW) I just measured and the largest part of the obj lens housing is 2.09", and the dust cap brings it to ~2.3". Mounted on a generic Crosman break barrel (Titan), with no shims, the dust cap has ~.024" clearance to the receiver. Without the cap there's .120" clearance. Something to think about if you need to shim the scope, so if needed you could sand a flat spot on the dust cap to gain room. Fyi; scopes, guns and mounts can vary with mfg changes over time etc., but at least you have some info to go on. The 1" version of these rings is ~.060" lower at scope center. Not sure why but fyi. The picture doesn't show a hole for a stop pin, but it does have one.
What is the saddle height of this ring?
It is 14mm from base to bottom of ring.
will this ring accommodate a 44 mm objective lens?
With a UTG 3-12x44AO (SCP3-U312AOIEW side focus) on my generic Titan, these rings give me .024" clearance. Without the rubber dust cover I have .120", which I mention since the cover can be sanded down if needed, like if shimming the scope. That scopes bell is 2.09". Fyi.
Depends on what gun you are mounting the scope on. If it has a raised rail it shouldn't be a problem. If it is directly grooved then it will be cutting it close, a high profile may be a better choice.
will these fit a 11mm rail?
Yes. The Leapers/UTG mounts are made so that one side of the portion you tighten onto the rail is 3/8" and the other is 11mm.
$200.00$149.99 $69.95$66.95 $69.95$66.95 $59.95$56.95 $59.95$56.95 $29.95$27.95 $16.99$12.75 $17.99$11.95