Roll over image to zoom in
90-day limited warranty
List Price $14.95 Save $0.96 (6%)
2X Buy and Earn 28 Bullseye Bucks!
other products by Hatsan
Create an online review and share your thoughts with other customers
Things I liked: The very simplicity of these magazines is amazing. No clockwork complications to worry about nothing to get dirty or gritty, truly optimal engineering at it's best.
Things I would have changed: Perhaps a way to tell when the last shot is fired. I color in one of the flats, ( with a permanent marker ), on the side of the Mag. and place it at the 1:00 position so when it comes around again I know it is empty. You can use several different colors on consecutive flats to let you know just how many shots you have left.
Things I liked: Multi shot capability
Things I would have changed: Clarify the guns these will fit.
What others should know: The magazines provided by PA did not fit my one year old AT44PA - they were too thick. PA was unable to help and I had to contact Hatsan USA directly. They exchanged the parts from PA for magazines that fit correctly. Apparently there has been a "minor" change that causes new magazines not to fit some guns. My original magazines were 10.5 mm thick. The parts supplied by PA were 10.9mm and did not fit the breech/receiver at all. The magazines Hatsan provided were 10.5 mm thick.
Things I liked: Performs as expected. Cycles without issue. Pellets are held in place snugly.
Things I would have changed: Nothing.
What others should know: I bought this to use with my .25 BT65 QE and must have missed reading where it comes with 2 mags. It actually worked out though as 3 mags (27 shots) is exactly what I get from a single fill.
Will it fit the new Gladius .25 cal?
Does this mag fit the Hatsan Bullboss
I have the Hatsan BT65 and I am having a problem with my .25 Exact King Diablo 25.39 gr pellets unseating after 1 or 2 shots. I have watched the videos and followed the instructions to be sure the pellets are fully seated before installing the clip. After 1 shot several of the remaining pellets will be backed out of the seated position causing loading problems and accuracy issues. Very frustrating to have to remove the magazine after every shot to reseat the remaining pellets. I have two magazines and it happens with both of them. Anyone have any suggestions