Loading

Main Operating Loading Firing Safety

Loading Pellets

Put the air gun "On Safe."
Point the airgun in a SAFE DIRECTION.
Push bolt handle up and pull all the way back until you hear two clicks (Fig. 4).
With the bolt in the open position, place one pellet, nose first, into the loading port (breech)(Fig. 4). This is a single shot pellet airgun. Load no more than one pellet at a time.
Lightly push the pellet into the barrel by closing the bolt and pushing the bolt handle down to lock. DO NOT jam the bolt forward. This will damage your airgun.
Be sure bolt is closed before firing. If it is not closed and fully locked, the pellet may not be discharged.

Unloading Pellets

Air the airgun in a SAFE DIRECTION, take it "Off Safe" and fire. You may also unload your airgun by following the directions listed under Removing Jammed Pellet.

Removing a Jammed Pellet

Put the airgun "On Safe."
Remove the CO2 cylinder.
Empty and remove the CO2 tank.
Open the bolt.
Insert a cleaning rod or ramrod of the proper size into the barrel. (Start at the muzzel).
Push the jammed pellet into the pellet loading port (forward of the bolt)(Fig. 5).
Do not try to reuse that pellet.
If you are not able to unjam your air rifle by following the unloading procedure, take no further action. Crosman Corporation or an Authorized Service Station will unjam your air rifle.