Operating

Main Operating Loading Firing Adjustments Safety

Parts of the Air Rifle

Operating the Safety
To Put the Air Rifle "ON SAFE"

Locate the safety directly in front of the trigger.
Push the safety from the left side all the way in. The safety is not "On Safe" unless it is pushed all the way in and the RED dot on the safety is not showing. The air rifle will not fire when "On Safe."
Even when the safety is "On Safe," you should continue to handle the air rifle safely. Do not ever point the air rifle at any person.

To Take the Air Rifle "OFF SAFE"

Push the safety from the right side all the way in. The air rifle is ready to fire when "Off Safe."
When you can see the RED ring around the safety, the air rifle is "Off Safe" and can be fired.

Removing the CO2 Cartridge

Put the air rifle "On Safe"
Holding the rifle by the forend, slowly turn the piercing tube cap allowing the release of the remaining CO2 before removing teh camp (Fig. 2).
After removing the cap, point the rifle down and the used CO2 cartridge will drop out.

Installing the CO2 Cartridge

Insert a new CO2 cartridge into the air rifle with the small neck of the cartridge inserted into the action tube first (Fig. 3).
Screw the filler cap completely into place by turning it clockwise with your fingers or with a coin placed in the slot in the piercing tube cap.
Point the rifle in a SAFE DIRECTION, take "Off Safe," and pull the trigger. If the air rifle does not make a popping noise after pulling the trigger, tighten the piercing cap a little more and try to fire again. Do not overtighten the piercing tube cap or use a tool on this cap. This can damage your rifle.
Return the safety to the "On Safe" position.