Date: 21/10/2018 20:17
0

Customers Q&A on Air Venturi Microbore Hose, DN2, Up to 4500 PSI, 1/8" BSPP Connectors, 24" Long

Add to Cart

In-stock

Got a question? Got an answer?
Log in, then enter your text.

  • Jacob from USA asked:

    Will this work on a Benjamin air pump for my Benjamin descovery?

    • Chris from USA asked:

      Can this be used to fill my carbon fiber tank from a shoebox compresse? Do I need any other fittings? Thanks

      • Rich from USA asked:

        Will this work as a direct replacement on an FX pump, or do I need any extra fittings?

        • Jonathan from USA asked:

          I know this can be threaded to extend the hose on the m4 hill pump but can this be used as a direct replacement for the original hose included with the hill?

          • Stanley from USA:

            Yes .

        • nathaniel from USA asked:

          Can I attach this to a hand pump?

          • nathaniel from USA asked:

            A way to bleed the remaining pressure with this?

            • Tyler from USA:

              There is no bleed mechanism here, this is just a hose

          • Mike from USA asked:

            I have a steel fire dept scba btl, with male threads & the hand knob on the side of the valve. Will this hose work on it...

            • ALVARO from USA asked:

              I can install it on a Carbon Fiber Air Venturi Air Tank & Fill Station, 4500 PSI, 90 Cu In ??

              • Big Shady from USA:

                Yes this MicroBore Hose will work. You will need this also Air Venturi Foster Female Quick-Disconnect to 1/8" BSPP Male, 5000 PSI Available here on Pyramyd Air.

            • ROBERT from USA asked:

              Will the female end screw directly into a freedom 8 compressor?

              • rong from USA asked:

                Does someone make a 90 degree fitting that i could put between this hose and my Hill pump? It would be easier o transport if the hose could be brought up parallel to the pump. It would take some strain off of the hose.

                • rong from USA asked:

                  can I use this to extend the hose on a Hill pump?

                  • Tyler from USA:

                    Yes that would work

                • Lester from USA asked:

                  Will this hose fit my 4500psi Benjamin Carbon Fiber Tank?

                  • Dan the Man from USA:

                    No, it has bspp threads. You need npt.

                • Jonathan from USA asked:

                  I put this on my Benjamin hand pump and the other end doesn't fit my Benjamin Marauder, what adaptor do I need?

                • Walter from USA asked:

                  Will the end fitting attach to the fill nipple on a Hipac? If not, what else do I need? Thanks

                • Norman from USA asked:

                  Can this replace the hose on a benjamin pump?

                  • Erika from U.S. Virgin Islands:

                    Yes, it can

                • Edmund from USA asked:

                  Can this replace the hose on the Benjamin scuba yoke, K-valve?

                  • Erika from U.S. Virgin Islands:

                    Yes

                • Lloyd from USA asked:

                  Will this replace ( fit ) the short hose on the Hill pump ?

                  • Tyler from USA:

                    You can actually thread it directly onto the current Hill hose.

                • Michael from USA asked:

                  Will this be a suitable replacement hose for the Axsor 3 stage pump?

                  • Val from USA:

                    Yes, this hose will work as a replacement for Axsor pump.

                Navigation