Date: 19/10/2019 19:45
0

Customers Q&A on Diana Stormrider Barrel Band

Add to Cart

In-stock

Got a question? Got an answer?
Log in, then enter your text.

  • Dominick from USA asked:

    how to install a barrel band on Diana Stormrider gen2? How do I remove the front sight and baffles to install barrel band?

  • Jose F from USA asked:

    Can it be installed by Pyramydair if bought with the rifle?

    • Peter from USA asked:

      I bought the barrel band to provide more support to the front of the barrel, however the band did not come with grub screws. Instead, it came with fill length screws as if I were going to install it as a replacement of the factory band. The screws are too long to install it on the front. What do you recommend?

      • Karl from USA asked:

        Will this band fit the Diana Bandit pistol?

        • Mark from USA:

          Yes it does, or at least it fit mine.

        • Mark from USA:

          No

      • none from USA asked:

        will this fit a Diana chaser (in 0.177 and 0.22 both with the pistol barrel installed)

        • Tyler from USA:

          Yes

      • jim from USA asked:

        What is the outer diameter of the Diana Stormrider?

        • Nathan from USA:

          Pretty sure he means the barrel OD - since he's asking about the barrel band. It's a question I had as well - I'm trying to figure out how to get a taller front sight on the Chaser rifle barrel without using this barrel band here, as there isn't a CO2 cylinder tube that far out.

        • Tyler from USA:

          Outer diameter of what part of the stormrider?

      • Bennett from USA asked:

        How do you get the extra barrel band on the front sight is not on the suppresor

        • Tyler from USA:

          You need to remove the barrel from the rifle and then place the barrel band on the air cylinder. Then replace the barrel making sure you install it through the barrel hole on the barrel band.

      • Pedro from USA asked:

        Will the band fit dragonfly ?....

        • Tyler from USA:

          No

      • Keith from USA asked:

        Will this barrel band fit the Diana Bandit Pistol?

        • Tyler from USA:

          Yes

      • Mark from USA asked:

        Any chance of getting the "Chaser" version stocked as it has the picatinny attachement rail rather than the lug?

        • Art B from USA asked:

          I just purchased the Diana Stormrider in 22.cal and the suppressor on the barrel of the rifle I have does not have a set screw on it and the front site is not on the front of the suppressor either it's behind it on the barrel. What's the best way too get the both off to install this Band? After thinking about it overnight, it's probably safer to just remove the Barrel from the Rifle.Thanks, Art

          • Tyler from USA:

            Best way is to remove the barrel and install it that way

        • Wild Bill from USA asked:

          I own a Storm Rider and am interested in adding a scope. I know it needs a compact scope, so I bought a 3x9-32 Bug Buster for it . Is there a way to remove the rear sight from the installed barrel band, or do you have to buy the one above w/o the sight and install it? Thanks, Wild Bill, Pa.

          • Tyler from USA:

            Sure, rear sight is easy to remove. First remove the screw in the top of the rear sight. Then take a mallet and tap the sight either from the front or the back and it will slide off the rail.

        Navigation