Date: 25/10/2020 8:56
0

Customers Q&A on Leapers 30mm Rings, Medium, 3/8" Dovetail

Add to Cart

In-stock

Got a question? Got an answer?
Log in, then enter your text.

  • Chris from USA asked:

    is this sold as a pair of rings?

    • Mark from USA:

      Yes

  • Matt from USA asked:

    I have a .25 marauder and have had the high rings for my 3-12x44 UTG s.w.a.t. for the past couple years but I don't like how high It Is. Will these medium rings work with my marauder and 3-12x44 utg scope?

    • peter from USA asked:

      Should these handle a 44mm scope?

      • Chevota from USA:

        I have the UTG 44mm with side focus SCP3-UGM312AOIEW and yes they clear, even after shimming the scope. The High ones are too high imo, looks weird, but up to the buyer.

      • Tyler from USA:

        That depends on the gun, most of the time, it's better to go with high rings if you're using a scope with a 44mm objective lens or larger

    • Ken from USA asked:

      Are these rings tall enough to mount my Hawke 6-24X56 scope on my Mrod field target rifle?

      • Tyler from USA:

        I would go for high rings

    • Mike from USA asked:

      New owner of a mrod.25 and for the life of me can't find where to put the stop pin or do you?

      • Tyler from USA:

        You don't use the stop pin on PCPs. Not needed

    • Brian from USA asked:

      What is the saddle height of this ring?

      • Cory from USA:

        It is 14mm from base to bottom of ring.

    • frank from USA asked:

      will this ring accommodate a 44 mm objective lens?

      • Chevota from USA:

        With a UTG 3-12x44AO (SCP3-U312AOIEW side focus) on my generic Titan, these rings give me .024" clearance. Without the rubber dust cover I have .120", which I mention since the cover can be sanded down if needed, like if shimming the scope. That scopes bell is 2.09". Fyi.

      • Erika from U.S. Virgin Islands:

        Depends on what gun you are mounting the scope on. If it has a raised rail it shouldn't be a problem. If it is directly grooved then it will be cutting it close, a high profile may be a better choice.

    • Daniel from USA asked:

      will these fit a 11mm rail?

      • Tyler from USA:

        Yes. The Leapers/UTG mounts are made so that one side of the portion you tighten onto the rail is 3/8" and the other is 11mm.

    Navigation