Will these work on a 3/8 dovetail?
Should these be ok to use on an FX Wildcat with the stock 11mm dovetail rail? Most seem to say the high rings work best. thanks
Will these fit a crossman redtail 22 cal air rifle?
Will these work on Umarex fuel with the picatinny rail it came with
No, you would need picatinny/weaver rings, not dovetail.
Will they work on a gamo whisper fusion mach 1, or would a 1 pc mount work better?
They will work but a one piece mount would be recommended. They are more stable.
How high is high? I currently have a scope mount that measures 3/4 inch from the bottom of the scope barrel to the top of the breach. I would like to raise the scope a little higher. Can anyone tell me how high these mounts are?
These rings measure 33.5mm from the bottom of the base to the middle of the ring. Hopefully that helps.
Will these fit on the Diana Stormrider .22cal Multi-shot PCP Air Rifle?
Hi will this fit the Mantis 4- 12x 40 and Umarex Gauntlet? thank you
Will this fit my Crosman 1377 with steel breech?
Will this fit a Beeman a Sportsman RS2
I bought a standard 1" gamo scope for my Ruger .22 pellet rifle and all of my shots are low. Additionally, I can see the front sight out of the scope when I achieve the highest setting on the top dial. Will this raised mount help both of these problems?
Yes these high rise rings will raise the scope. In most cases depending on the height front sight, the rings will position the scope above the obstruction.
Will the Vertical stop pin center up (go in the hole) over the holes on a 11 mm dovetailed receiver (Hatsan Mod 95 Vortex)?
Will it fit the gamo bone collector bull whisperer airgun .177 cal
Will this work with Benjamin Marauder?
yes this will work, just be sure of your tube width on your scope and front lens size
hello is the recoil pin removable? using on co2 rifle
Yes and Yes.
will it fight on a powerline 856 pellet gun?
If you are referring to the 853 single stroke rifle, these rings will fit that gun.
Is that a screw on the bottom of the ring?
Yes and the stop screw is adjustable and/or removable altogether.
Yes, that is a stop pin for spring piston and gas piston rifles.
will these fit a daisy 880
Will this allow a 4-16x40 center point fit a Benjamin titan NP?
Yes, but you would be better off with a one piece mount.
How will these work on a RWS 34?
Not well, use a 1 piece mount instead.
They will work just fine but I would recommend a good one piece mount instead of the two piece mount on a springer like the 34.
Will these fit on my Crosman 1377?
Not without CR-459MTC [Crosman 459MT 2-Pc Intermount, 3/8"...]
UTG LEAPERS 8-32X56 ACCUSHOT SWAT AO Will these rings Accushot 1" Rings, High, 9.5-11.5mm Dovetail Work for above scope? Will be mounted on BAM-51, 11mm dovetail.
No, because these rings are for 1" tubes. You need a high ring that takes 30mm one piece base like Leapers Accushot 1-Pc Mount w/30mm....