Last ? Do you need the air venturi male quick conn adapter for the fill prob? Or does the fill prob have the quick conn already machined into it?
You need the adapter Air Venturi Male Quick-Disconnect, 1/8"... if you have a female foster on your air supply hose end. If it is a female threaded fitting the probe will screw into it.
The pic for the .177cal doesn't look like the gun is shrouded, but the specs say it is. Just want to be sure before moving fwd. Thanks
The .177 cal we currently have do not have the shroud mounted. The next batch of guns will have the shroud mounted. The 25 cal are shrouded.
Is the shrouded end threaded? Meaning can a additional moderator be screwed on to make the gun queiter for extreme backyard friendliness?
The barrel end is threaded. You can mount an aftermarket suppressor on the gun.
What hand pumps are best for this rifle?
The best hand pump is the Hill Mk4 kit with the dry pac. Here: Air Venturi MK4 Kit by...
I don't like the magazine that comes with this rifle. Will the Marauder or Gauntlet magazines fit the Kral PCP rifle. They look real similar.
They will not
Does this gun have an air gauge?
I'm ordering this rifle with a UTG Leapers 4-16X56mm Swat scope with a 100 mm side focus wheel. Will the focus wheel clear the magazine? I noticed from the photos than the magazine protrudes a fair distance out of the left side of the action. Thanks.
Thank you, Tyler. I also ordered a 60 mm wheel. I may try cutting down the 100 mm wheel to make room for the 100 mm wheel.
Not likely. You'd have to use the single shot tray (if you're getting a .177 or .22) when using the larger side parallax wheel.
Any idea what the trigger pull is on this rifle? I know its adjustable, but I would like to get an idea of the range of pull weights.
Kral states 3lbs down to just under 1lbs. Out of the box, the one I tested was around 4 lbs. Looking at the trigger it can certainly go lighter than that, but I have yet to adjust one at this time.