Could these be used in a Hatsan 95..thanks
Yes. Shoot 3 at a time to keep the back pressure up to avoid damaging the piston seal.
Can you load a pellet first and then, in a break-barrel load a cleaning pellet?
I load the felt cleaning pellets first, one or two, or however many you prefer, I load a flat or dome head pellet immediately behind them. I usually shoot them into the air. I gather it, or them and inspect them for dirtiness. Will repeat until satisfied. I stop using them in my Umarex Octane. They tend to get stuck in the baffles of the SilencAir. Shooting these out is less messy and faster, my opinion. Woodys World.
Can you use quick cleaning pellets to clean a Benjamin Trail NP .22 Cal. air rifle?
We would not endorse cleaning pellets. You would need to shoot at least 3 at a time to prevent the piston seal from slamming into the air chamber end.
Can they be shot through a PCP rifle that has a n attached LDC?
How about gas spring rifles?
If it doesn't have baffels, you'll be fine. Just put 3 in at a time.
same as for rifles. Pistols are generally less powerful than rifles.
Do these cleaning pallets create enough resistance to keep from damaging your spring operated pellet rifle? In the reviews I have read their leaves to be some questions about this! Some folks say to stack them, some folks say not to use them at all?
if you are shooting a spring powered magnum air rifle, then this might be a concern. That's why some folks to suggest stacking them. Shooting in PCP/CO2 or less powered airguns should not be an issue. If concerned stack them!