Date: 3/12/2020 15:13
Main  |   Operating  |   Loading  |   Firing  |   Adjustments  |   Safety

Changing the foresight elements.

  • Make sure your air rifle is "On Safe."
  • Loosen the rear-knurled bush until the slot holding the foresight element is free.
  • Remove the element by holding the two protruding side lugs and pulling it rearwards and upwards.
  • When inserting a new foresight element, ensure that the side lugs of differing width are matched up with the slots, also of differing width. When using plastic elements, remove the knurled bush completely, insert the element, and put back and tighten the knurled bush.

Adjusting Trigger
The trigger has been set optimally at our works.
Adjustment of the finger rest (a+b)
The finger rest can be adjusted vertically, longitudinally and can be swiveled.
Trigger pull (c)
Turn anti-clockwise for reduced pull, and clockwise for greater pull, Trigger slack (d) Turn anti-clockwise to increase first-stage travel, and clockwise to reduce it.
Sear engagement (e)
With the trigger cocked, the screw is slowly turned clockwise until the pistol shoots. Then turn the screw anti-clockwise for about 1/4 to 1/2 turn.
Trigger Power (f)
Turning clockwise increases, turning anticlockwise reduces trigger power.

Stock adjustment

1 Swivel of butt plate
2 Setting of stock length
3 Height adjustment of cheek piece
4 Length adjustment of cheek piece
5 Lateral offset of cheek piece
6 Inclination of cheek piece
7 Setting of shaped grip
8 Setting of front stock

Main  |   Operating  |   Loading  |   Firing  |   Adjustments  |   Safety