Page 3 of 4 - AirForce Talon/Condor Swivel Stud Reviews

After 3 weeks of use, it works fine and was easy to install.

Nothing

fit my Talon

the diameter of the through holes are too small for use with my 48 x 1.25 Grov Tech Sling. This combination WILL NOT WORK!!!! without alteration. I opened up the through holes x .020 to make the 2 products work together---easy if you have the proper tools

must reverse the butt plate for use with the Air Force Ass Bar--NO DIRECTIONS included

would give a higher rating but alterations are needed

The front mount fits on the rail and locks in place.

Although fairly self explanatory, there are zero instructions with this item. The very small allen wrench provided, may tighten the front mount to the rail, but will not remove it without breakage. Maybe a small amount of lube would help, but no instructions to state so. The rear mount does not fit the rifle if any modifications have been done to the butt stock. This should be a part of the write up so these are not purchased by folks that have done mods. There is no place to install the butt stock mount if mods are done!

You will need to buy a different butt stock insert in order to make this work if modified but stock has been installed.

Made from steel.

They rattle. Come on Air Force for the money you could have put an o-ring on them to prevent rattling. These pieces are too expensive for what they are.

easy to install

make the holes bigger

The swivel holes are too small for standard sling adapters and need to be drilled a little.

Works as designed.

Make the swivel holes bigger as I had to drill out the holes to accept a standard swivel sling. This is a simple fix, but I should not have to do it.

Makes carrying your loaded Airforce rifle much easier, especially when hunting.

Easy installation and high quailty. I had no problem fitting and tighting the front swivel to the front rail of my Condor. When tightening the front swivel you are actualling compressing the swivel to grab the rail. It feels like excessive torque, but the swivels are high quality and will easily accept the torque.

A better explination of the tighting process in an instructions sheet.

metal,fits perfect on talon pistol and all other Air Force prods.

nothing

just that if you want to use a sling this is thebest way to go

Nothing

Make them work as they should

Front stud will not tighten to rail

great quality

nada

giving two bases you can have two tanks set up, I mount them to butt stock, works great