Page 3 of 3 - Hatsan Magazine, 10rd .22 Cal. Reviews

perfect fit looks like factory mags

a finer finish would make it easier to load

these need the pellet holes cleaned i had one that the pellets didn't slide as well as it should after cleaning i sprayed with dry PTEF spray and let it cure over nite, i can push the pellets in very easy, be sure to remove the o-ring before cleaning or spraying

Simple and effective, holds most pellets in place even when jostled.

Needs a bit more polishing. I used some emery cloth to put a high polish on the flat face and remove a few minor burrs on the pellet chambers.

When replacing the o-ring, need to use a 22x2.5mm ring.

It is nice to have 10 rounds on each load on my Hatsan AT44W-10. Just use the side bolt handle snd advance the magazine clip, count to 10 and reload.

Well not much, I am in a process of comparing ghe 8 clips I own. I marked the smooth side of each one with a different color of marker and keeping a log book to detetmine if any of the little mag clips are less effective then yhe other. Do far they are all the same. I colored the entire back so I could see a wear pattern in the colored surface and thetefote spot a out of balance or out of alignment.

I do suggest thst you keep the rubber rings that help hold the pellets in places are lubed so they dont dryout and crack.
Also if you preload them and carry then in a little case then you need to check them when they have been stored. I cut the head off from an old tooth brush and use the rounded handle to reset the pellets in the mag clip before installing then in the rifle. If the clip is installed with loose pellets you will notice a weaker pattern when using that clip.

Price is cheap and easy to use.

Nothing.

These mags will fit Hatsan,Hammerli,Webley and HaleStorm.

Very easy to load pellets, it keeps them in place . Well made , excellent quality for the price

Nothing-- good the way it is

Keep a few extras..

Easy to use and great price .

Nothing.

They are cheap so stock up.

It was free and it holds 10 shots

Nothing

Well not much to say, it holds the pellets and it it works!

The simplistic style and easy to use. The external o-ring is easy to view, inspect for damage or defects and holds most pellets very well.

A numbering system so you could see at a glance what shot your on would be a very helpful thing. A little thicker too. Very long pellets like JSB Monsters or predator polly mags stick out and do not permit proper cycling of the magazine.

If you like having a loaded magazine on hand that doesnt give you away on a stalk then this system works great.

Clearing a jam pellet can be a very frustrating affair.
Be extremely diligent when seating your pellets. They MUST be all the way with the skirts flush with the wells in back for the rifle to properly cycle and for any hope of accuracy.