Page 2 of 6 - Quick-Disconnect Male Fitting + Reviews

Very good service ,fast and good product, thx

Great product, works like it should.

nothing

Lot better than the probe.

Much better than the old probe fill, easy to install.

20.00 for a quick connector seems way high, just sayin.

It does make the fill of my airguns much easier than the old fill probe did, get the hard dust cap to keep it clean.

Metal Durable

The picture..the one in got is shorter tappered and has a skinny o ring.

The one i received had a tappered end and the o ring was way skinner than shown it has the same threads as the original that comes on the Sumatra 2500 but is almost half a inch shorter this added with the skinny oring made it so that I was un able to fill my rifle. PA is mailing me replacement though.

This item was received in a timely manner and in it self is a well made part. It installed easily and works well with a standard Parker Female coupling, However the Air Venturi Inline pressure Gauge, 0 to 4500 psi would Pop off at 2300 psi and I would Not recommend using that combination of parts

Nothing

Do Not use the Air Venturi Inline Pressure Gauge, 0 to 4500 psi item no.(AV-00031) with this part. the Coupling
Pops off at 2300 psi and permanently Damages the Coupling Sleeve

Easy installation on the Sam Yang 909.

A threaded cap would be a nice addition. I am not sure how long the rubber cap will stay on while hunting or doing field work.

Pyramid Air is a top notch company to do business with, all of the people that I have talked with over the phone have been most polite and very helpful.

MAKES EVERYTHING EASY.

NOTHING

TRY THEM.

Replaced Sumatra 2500 old slide in air fill system that always leaked and needed o rings repair all the time. Followed directions on PyramydAir and unscrewed a fully pressurized system and no leak, thread in new quick disconnect fitting with no problems. Real satisfied with this quick connect fill. Would recommend purchasing,

- a better cap on end when not being filled. The current item is a slide on plastic cap and can fall off

Works well for the intended purpose, although for my Career II I needed to reuse the original "o" ring as the included "o" ring would depress the valve in the air chamber (causing the gun to leak). For the Career II the "o" ring needs to be closer to the middle of the fixture as opposed to the end.

Include a thin flat washer to help support the "o" ring on the Career II.

Eliminates the need for a different fill probe for each different rifle you might have in your "inventory".

The item makes it easier to fill my air gun.

My first one had some sharp edges and was very hard to install so I called pyramid air and they sent another one immediately. It was still hard to install but the tech. rep. said to go ahead and use pressure that he would make right any damages if it caused any. No damages occurred to my knowledge and the fitting did go in.

Pyramid air is a very efficient group with friendly service. I highly recommend them.