Page 5 of 6 - Quick-Disconnect Male Fitting + Reviews

Very quick to install. Works like it should.

A better protective cap (maybe a threaded area behind the fill nipple end with an aluminum cap instead )

The rubber protective cap you receive will likely be too loose to use initially.
All that needs to be done for a tight fit is to apply (some) heat to the rubber cap with a lighter, torch, hairdryer etc..
Be careful not to burn yourself or anything.
Take a pair of needle nose pliers and hold the cap by one lip and apply heat very quickly (VERY QUICKLY) or the cap will just melt if fire is applied in one spot for too long. The cap will shrink (think shrink tubing for electrical wires) Bam.. Done

Makes filling multiple guns a snap. No more positioning the rifle 'just so' to use the probe with a hand pump(short hose). Also, no more replacing the o-rings on the probe. Simple to install.

More substantial cap... not needed on my Infinity

much easier to switch between my different PCP rifles

nothinh

Installation was very easy and it works exactly as advertised. I can fill my Crosman and Samyang guns from the same source now.

I really wish there was a cap for this other than the included sleeve. It's partially aesthetic but also functional; the adapter just hangs out there on the Samyang now. Also, it's pretty spendy--$40 to get it here if ordered alone. It'd be nothing if my gun was unfillable but this was just an accessory.

The second one I ordered was machined incorrectly and would not function. Pyramid Air took care of a refund and it was no longer an issue--just make sure you check yours to match to the pictures when you get it!

perfect fit for sam yang dual tank .50cal dragon claw

perfect, needs no change

removed the original sam yang probe & replaced it with this qd fitting, makes filling with tank easier

Saves a lot of aggravation. I have 4 pcp's with forester fills and then bought a Korean gun. Unscrew the old probe fitting and screw in the new!

Charge a little more and give it a good looking cap.

No need to switch back & forth from one fitting to another to fill different guns.

low price, easy to install

make a better fitting dust cap

Fits on my sam yang 909 with no problem, set up was easy as A B C, you will not be disapointed. Use 100% silicon oil on the foster fitting before you put on your quik connect, cause its difficult to push on the connection and get it to lock if the fitting is dry.

IF YOU HAVE A SUMATRA AND WANT TO FILL IT WITH THE DISCOVERY PUMP THIS IS THE WAY TO GO. easy to install check out the video. comes with seal

nothing

be careful treading go counter clockwise first easy-- and then clockwise by hand to start-- and do not over tighten with wrench

nice to have this adapter. i got tired of replacing o-rings on my carreer filler with the 2 o-rings.this adapter fits the foster attachment and i am going to replace the others with an adapter to fill my daq 308 so i will only need one hose to fill my guns.

it would be nice to have other adapters for other guns

very happy with pyramid air.the original adapter was lost in the mail and was replaced quickly.all my other dealings with pyramyd air have been very positive

Converted my Sam Yang 909s to use the same fitting as my Marauder .25. The Sam Yang had a tendency to leak during fill with the old fittings.

Nothing really. It's simple, install is simple, and it works.