Page 7 of 7 - BKL 1" Rings, 3/8" or Reviews

High quality

Nothing

Not for springers unless you use a scope stop. Works good on pcps.

Nicely made, nicely finished. Best rings I've every bought. I really like the clamp design, super solid lock up. The "spreader" feature is awesome, I wish my intermount clamps had the same feature. Made in the USA. Excellent packaging, you don't have to destroy the package to get at the rings.

Nothing.

If you are hesitant about ordering BKL rings because of the price, try these out. These are a rock solid bargain. After you try them, you'll understand that BKLs are worth every penny and then some.

Rings clamped up tight on dove tail I found that tighting dovetail screws on the bench and backing them off before puting on gun signifantly eased instalation on gun would buy these again

I used two sets of these rings to mount a Leupold VX-I, 2-7x28 Rimfire scope and an FX-3, 25X40 on a CZ-453 rifle. When changing scopes between the same rifle the zero point is only affected by 1 or 2 clicks. Better than any other setup I have tried for 3/8" or 11mm grooved receivers.

Nothing

Can be used on 11 mm or 3/8" rails

The quality and design are top-notch. The ability of these rings to fit most any dovetail while remaining centered is a big plus also.

Nothing.

They work fine on my 13mm BSA dovetail.

Fit a 3/8 dovetail properly, light weight, scope held firmly but not damaged

Get them to publish the actual heights of the rings, not just "regular" and "tall"