Page 2 of 2 - Replacement Probe, 1/8 BSPP, Fits Reviews

Item needed to refill airgun

Cheaply made of potmetal. I have gone through 2 of these. Can be dangerous when they break. Hold gun very steady when filling to avoid any additional pressure on this probe.

good probe for the money

but seals on the probe can be a little more air tigh

Shipping for this Item is more then what it need to be can be shipped for $5.15 with tracking with usps

Replaced my broken one lol

price, finish, better grade o-rings

I've tested the o-rings to 3600psi, though they are low grade they are up to the test of filling strong valved sam yang rifles

does the job what else could one expect from just looking at this simple part. material wise its a probe end of story- i bet at the machine shop they are shot out by the hundreds by an automatic machine.

THE PRICE why? its a part that can be damaged very easy because it has fine theads and is made of bronze- bet made in china

its way over priced. pyramyd: make money in other things these parts should be value added perks to the customers- reduce the price-the profit comes from getting more pcp customers!

Fit like it should works good

nothing

nothing

I had tried to use my Hill pump to air up my Shinsung 9mm Career Ultra for months without success before I finally got one of these probes. The original set up required a series of adaptors to allow the British pipe threads of the Hill pump to attach to the American JIC threads on the original probes that I purchased, Because of this series of adaptors, I could not seem to stop all the air leaks. After buying one of these probes that have the same British pipe threads as the Hill pump's supplied hose, and getting some silicone o-ring grease I finally got a good air seal and was able to pump up my gun.

Nothing!

It you have a Hill pump and a Shinsung Career air gun or similar, GET ONE OF THESE PROBES!

well its purely a replacement part but works as intended

should be made of stronger metal, the original one i got with my gun broke in half, needs to be around 10 bucks, which would be more worth the price

make sure to keep it clean, i suggest getting the quick disconnect fittings, so you can take it off and say keep it in your pocket or if you have the AIR venturi g4 hand pump keep it in the handle

Sturdy construction; looks like the perfect probe for some guns--just not mine.

Make it clear somewhere in the advertising that it is not for a Sumatra Carbine--too loose a fit--air leaked a lot every time I used it.

While I did manage to fill my Sumatra Carbine with it to (almost?) full pressure, the leaking was a pain. I was able to improve performance by careful wrapping of the ends of the shaft with Teflon tape, leaving the air holes unobstructed, then lubing with silicone grease. My next experiments would have involved using fine thread to hold the tape in place, but I finally decided to purchase a male/female pair of quick connect adapters, which are (comparatively) a joy to use and waste no air at all.

sturdy, easy to use

add a quick disconnect instead of the screw on threads

if you're using a hand pump, make sure you don't pull on the fill probe, loss of air, even small amounts at high pressure, are a pain to pump by hand.