Page 2 of 7 - Bullseye ZR, for 1" or Reviews

None

The tolerances on this product allows to much slop to maintain a zero of the mounted optic. I attempted to contact PyramydAir customer service several times and was always on hold for 20 minutes at which time the hold system would drop me. I tried two or three times a day for I think three days and just give up and accepted that on one was going to answer the phone so I will just eat the cost and never order from PyramydAir again.

My Gamo Bone Collector Bull Whisper has destroyed every optic I have put on it. So if you are considering an Air Rifle then get one with iron sight that is optic ready and good luck finding an optic that will last. The best luck I had is a cheap $30 red dot tube that the switch finally jammed up on but the dot stayed zero.

Easy, secure installation and function.

Perfect

YouTube video to show installation would help a novice.

The very solid build and it will definitely save a more expensive scope if you choose to mount it on a air rifle.

The overall size. Its long! It barely fit my UTG Hunter that is 15inches long. Dont even think about purchasing this if you plan to use any type of short tactical scope.

Use loctite on all the screws even the four inside the ring.

Great concept

It broke almost immediately. Slide rail fell out. I used hammer to get back in slot. Stop pin sheared off after 100 rounds and can't screw in last bolt threw sheared pin. Spring is shot. Not much higher quality than spring in a bic pen! I'm not exaggerating. Hard to believe PA would sell anything that is guaranteed to break

if you can design one of these that works it would be a hit

The fit and finish were great, should work great just about the same principle as the old Lyman and Unertl scopes that moved during recoil. Tighten the side plate down good and snug and this thing wont move. I mounted it on a Hatsan 135S QE 30 caliber Springer with a Mueller 4.5-14X scope.

the only thing would be to make it a bit higher so any scope can be used and maybe instead of one spring make it a double setup.

This is something that only time will tell nut I would use it again. watch the ring liners to reduce it down to a 1 inch scope that you don't loose them.

Great solution. I will be able to use a higher priced scope without fear of erector damage.

No changes.

Works like a dream.

The packaging

The description, title and picture.

It's going back. The mount I received is actually labeled " Diana" and made in China. Not as pictured.
If I wanted a twenty dollar mount a would have bought one.
Quality is lacking.
Ike

Seems well built and slides easily. Arrow on frame shows correct mounting direction.

Nothing

Too early to tell if it really works. Only continued use will tell if it really does protect scopes from the double recoil of springers..

I like the four screw straps to hold the scope. I really like the interlocking pinned aluminum (not plastic) inserts for a one inch scope tube. The scope returns to the original position after every shot. The quality control seems to be top notch - little to no slop.

Of course less expensive would be better but compared to the Chinese knock off recoil mounts you DO get what you pay for!! Although designed and engineered in Germany I would prefer the unit be produced in Germany or the USA. The scope stop pin should either be eliminated or made more robust.. As it is it's just kind of a joke.

This is a great way to protect your scope on those magnum (and even not magnum) spring piston airguns. Adding a bit of droop compensation is a nice touch but it's not so extreme that you can't compensate for it on a gun with no droop.

Really does its job. Perfect for a hard recoil, high powered air rifle.

nothing