Page 2 - RWS Air Chamber Lube Reviews

Always high quality as expected.

Don't over lube.

It works

Nothing

N/a

If you use airguns othrer than co2 guns this is a must have treatment for the healt of gas piston and springer and pump up guns even some PCP have it recommened on certain seals. my nomad II pump eat this

nothing

must have if you want your guns to last

Its what the manual recommends so...

The price its pretty expensive for the size of the bottle you get .I was hoping it would load my magazines and mop the the floor for that price.

It did not load my magazines OR mop my floor .the cap broke and the needle won't fit .90% silicon grease at.Lowe's hardwAre .$ 3.00

Have been using this for AirVenturi Nomad II air compressor. Not using the metal tip just punctured a small hole in the plastic tip and works well. Has been keeping the compressor running great so far. About 10-15 fills on my pcp airguns.

Price seams high.

Metal tip has threads but the plastic tip is not threaded so to get it on you need to press the two together as you screw the metal tip on. Remember to open a small hole in the plastic tip first.

Not much!

The needle dropper tube that came in the package will not screw on to the bottle. I had to find another bottle with a tube that would work in order to use the oil!

use for nomad 2 compressor

nothing

works very well. one drop will do ya every 1000 shots or so

n/a

use on piston seal. chamber only. and use sparingly only when needed. usually after 1000 shots or so. works well. a must have...

I like the extension that came with the bottle. Helps with hard to reach areas.

I do not under stand why the extension is not incorporated with the cap. When the extension is removed you lose some of the silicone when you remove the extension. It is a waste. I ordered some bottles with the extension molded into the cap. When I get them I will transfer the liquid silicone to one of these bottles. I will not waste any of the silicone, it will flow back into the bottle.

No.

I have not use this product yet but definitely a little insurance goes a long ways to make your rifle perform at its best

I do believe in is quite a bit overpriced

It may be a little bit pricey but it's well worth the money to have the insurance knowing that you're rifles seal is going to last a lot longer because you cannot use acid-base lubricants in a lot of these newer air rifles and people should be aware not to use regular oils

Good product

Nothing

Eddie

Can't beat RWS. Great stuff.

NUTHIN'.

The needle is long enough to get into most chambers and you get a decent amount.

Oddly enough it does not say "silicone oil" on the label and does not state it is for high compression airguns nor does it mention dieseling.

Fine product overall. The dropper needle works very well.

Nothing

If you have an FAS 6004 this is a perfect tool to apply a few drops to the felt seal inside the compression chamber through the little hole on top of the cylinder. It made a measurable fps improvement in my pistol.

Excellent quality overall. Heavy-built and smooth threads

Nothing

RWS Air Chamber oil has a needle to put the drops of lubricant where it belongs. I have yet to fire my RWS model 48 side cocker after putting a couple of drops of oil into it. I never knew until reading on Pyramyd Air that a silicone is required in spring air rifles.

The price of this product is a little expensive and also the shipping for a small bottle of this RWS. Then only reason I did not rate this product higher is because of the price of Silicone oil and the shipping price.

No I have not tried any of my spring air guns with this oil but I will fire my RWS soon.

I bought my first air piston in 1973, a Crossman Mark II. I used Beeman chamber oil for years. I ordered this my last order, and can tell no difference in function of my old Crossman after thousands of pellets and 43 years of use. I believe that using this oil is the reason my Crossman still functions. All I have done is replace the O ring on the pellet seater, and a couple of O rings in the Co2 chamber.

The only thing I would change is lowering the price. I'm 82 years old living on a fixed income.

Price

Nothing

This seems like a small amount but at a couple of drops per 100 shots it will last a long long time. It will keep your rifle shooting for a long long time without having to replace you piston seals.

easy to use

drop the price. It inst that special

HEARD OF SOME RIFLES THAT WERE NOT LUBED PROPERLY AND I PUT SOME IN MY RWS 48 LETTING IT SIT A DAY OR SO . SEEMS TO WORK WELL

NOTHING

NEEDED FOR GOOD PERFORMANCE LIKE ENGINE OIL FOR YOUR CAR