Page 12 - Air Venturi Male QD, 1/8" Reviews

It was a good price. It worked great and had no issues. I've used it on 5 different adapters and never had a problem.

Lower the shipping costs if we order just this part. Shipping was almost as much for the part as the price of the part.

I was told by someone who works with high pressure tanks to use pipe tape. It's not for air leaks but to make the install and removal easier and smoother. Also make sure you screw enough to make contact with the seal. It depends on the length of your adapter how far you need to go so don't just screw it all the was down or you may deform the seal and cause it to leak.

Works great and allows me to switch quickly and easily between the 2 different guns

Nothing

Use some PTFE thread tape and ditch the worthless seal on the bottom

It works great.

Lower the price a couple of dollars.

It's inexpensive and it works fine. Have used it several times on Hatsan 44 with no issues so far.

Nothing.

A must have to connect different connections. Manatory....

Nothing really

If you get a good one they work.Out of five I have three work,one had a bad seal,and one had no threads.

easy to use, can use to make many adapters

this is my second of these, first one fit perfect this one is hard to get connector closed on to it.

confirm seated well in connector, I did not once got bruise on hand. silicone grease helps

how simple it was to use. I used it for the hand pump that you buy for the Benjamin marauder, for my hatsan.

cant really complain about anything

check your threads to make sure this will fit whatever your buying it for.

It looks like it would work.

The first one of these I received was stripped- I think they sent one that someone else had sent back. The replacement I received leaks and the delrin seal is useless. I'm not sure what alternatives there are but I'm not so pleased with this.

It leaks.

Well made and works good.

nothing

Great for connecting probes to quick connects

Just what it says, quick release. No if or buts. It is what it is, plain and simple. Screw it on a filling probe, use teflon tape please, just to prevent leak. Not that it'll leak air.

Nothing much to change. Design is perfect for it's function.

Pricey. It's $10.00 just for this piece of adapter. This is mass produced and not individually carved out of as solid chunk of steel.

Works just fine if you use it correctly.

nothing

I've seen negative reviews of this item but you just need to be careful not to under or over tighten to make it works well. Pay attention when initially securing it and it works exactly as it should. No teflon tape needed.

Well made adapter. Thank goodness for quick connectors

Purchased this to connect a Sam Yang rifle to a Benjamin Pump. Works great so far.

The black coating flaked off a little...not sure if this could contaminate the air chamber or not. Just keeping my on eye on it. No problems.

It works

$10 for a fitting !!!

May be able to find alternatives at hardware store for much less. BUT then again, time and gas all adds up.

It gets the job done. I needed it to fill my Pneuma which hooked to their fitting so I could attach to my Benjamin pump.

Wish it was stainless for the price.

Would suggest using teflon tape when you install it.

The nylon washer alows presure to bleed off when I take a break.

The way it seals

Good workmanship, a little Teflon tape and it mated up perfectly with my Evanix fill probe.

N/A

Make sure you have some Teflon tape.

worked perfect and the price is reasonable

nothing

This connector works great. I have the Benjamin High-Pressure Hamd Pump and I separated the hose from the pump body with this connector Screwed onto hoseend that came off of the Pump Body.

nothing