other products by Air Venturi
Things I liked: I got this for my Texan it is dead sexy and makes the rifle feel sturdier
Things I would have changed: Instructions would be nice but not really required
What others should know: While it will fit on the Texan it requires a little creativity
Things I liked: Nice Looking addition to my Condor SS
Things I would have changed: It's little rough around the edges.
What others should know: Had to do a little gunsmithing as stated in instructions for my gun. Turned my butt plate and clamp over then drilled a hole though butt plate and back side of stock near the bottom of the stock. Tapped the stock with 8/32 and screwed the butt plate to the stock. Maybe not nessesary but I have my sling mount on the butt plate and wanted it to be very solid.
Things I liked: Nice addition to Condor SS. Matte Black finish w/a few burrs which are easily removed. Fit tight into pistol grip with a thumb screw and a sturdy hook, the other end has a 1/4" pin that fits into the butt plate on the tank. The whole installation is very ridged once fastened underneath the tank. Does not wobble at all and ties the Pistol Grip, Tank, and Butt Plate together nicely.
Things I would have changed: Would like to have all the edges rounded and the whole stock powder coated for this price. I re-sprayed with high quality BBQ Primer after removing the two burrs I found.
What others should know: Way better looking and way better construction than the Air Force item.
Will this fit on an Airforce Escape?
No it is designed for the larger tanks (Talons , and Condors )
Will this stock work on the Texan?
Yes it will fit. Here's how I made it work the butt plate has three holes the center hole is attached to the bracket that attaches to the tank remove that screw and invert the bracket so the flat part is on top of the tank reattach the butt plate to the bracket using the top hole now attach the stock normally
didn't fit mine without heavy machining.
Yes it will fit.
What machining has to be done to this part to make it fit a spin loc tank?
No machining is needed it will fit the spin-loc tank also.
I would contact airforce airguns for there help , they are very helpful.