Roll over image to zoom in
1-year limited warranty
List Price $220.00
Only 2 left in stock
Earn 140 Bullseye Bucks
|Max Velocity||1000 fps|
|Cocking Effort||31 lbs.|
|Trigger Pull||3.5 lbs|
Create an online review and share your thoughts with other customers
Things I liked: General construction, weight, fit and finish are good. The bundled scope isn't bad but the supplied mounts would not stay tight even with blue locktite. Retightened all after each bundle of 25 shots as this rifle has more spring recoil action than most mention. After a bit over 100 rounds of firing Beeman ultra magnum heavies (10.5g) the mounts became loose enough that the rear scope mount slid back and sheared off the pin that was supposed to keep it locked on the receiver.
Things I would have changed: Put a good strong 11mm to Pickatinny mount on the receiver first, skip the supplied scope mounts. You will need new mounts for the Picatinny rail but that is not an expensive proposition. The supplied scope is fine for the bundle cost.
What others should know: Had severe barrel droop from the start, well outside the vertical adjustment range of the Beeman-branded scope. I have a UTG 11mm dovetail to Picatinny compensator mount that I may have to use on this rifle, although I had planned to install it on my Browning Leverage but may have to use it here. The mount has only 4 screws to hold it to the dovetail so since I have no holes left for stop pins, I may end up trying JB Weld between the mount and receiver, hoping that will be a stable platform, since the sheared stop pin stuck in the receiver voids any chance at warranty repair.
Things I liked: I liked the power, scope, the high feel of a quality product. Was very impressed! But then:
Things I would have changed: A different way of cocking so the scope is tied into the Barrel.
What others should know: I could not sight in the scope. I was only 50 feet from the target and it would shoot high 4 inches then low 4 in. It was all over the place. Then I found out why. I held the gun buy the stock and wiggled the tip of the barrel. There was a good 1/8 in movement at the break point were it cocks from. This would not be a problem if you just used the sight because its mounted to the barrel but the scope is not. Bad design. I returned it the first day. All that power and niceness is no good if you can't hit any thing.
Things I liked: Beautifull wood and a nice weight and feel. Trigger on mine is 3 lbs 1 oz a slight bit of creep but good. Nice powerful accurate springer.
Things I would have changed: Get the creep out or make trigger adjustable.
What others should know: Excellent buy. Fun to shoot with execclent sope if you take the time to adjust it. The scope has crytal clear optics when setup up right. A reare gun not needing any extra except a lot of pellets. Amd priced right too.
It states the scope is not mounted?? is mounting hardware included? does the gun have a mounting rail? is it drilled and tapped for scope mounting? Obviously more info is needed on the scope issue.
If you look at the pictures it's got dove tail grooves to mount the scope rings to no drilling or tapping it's all set for mounting.
Yes, mounting rings are included.
what does it mean when it says that the scope is not mounted
It means the scope comes in the box, but it's not installed on the gun. You would need to do it yourself.
Is this made in China?
|Max Velocity||1000 fps|