Special tape inside the rings keeps your scope tight without excessive clamp pressure!
Roll over image to zoom in
Lifetime limited warranty
List Price $19.95 Save $5.00 (25%)
Earn 15 Bullseye Bucks
Create an online review and share your thoughts with other customers
Things I liked: sure stops mount creep with lock screw.Have a ruger air mag. in 22 cal. Very accurate and hard hitting.so much recoil,it would continually slide the mount back,but with this Leapers Accushot 1-Pc mount, it locks on secure,no problem.
Things I would have changed: Nothing
What others should know: Get one
Things I liked: Nice one piece mount very sturdy and has a much needed stop pin. Great price point!
Things I would have changed: Have the bolts that tighten it up to the barrel flush with the mount and I had to work on the stop pin to get it in the machined hole in the gun so I guess it needs to be better drilled for alignment.
What others should know: First one I received I had to return because one of the scope mount holes was drilled and tapped at such an angle I could not mount the scope however Pyramyd Air made things right!
Things I liked: Outstanding mount! Looks really nice and is super strong with super clamping force on the rail.
Things I would have changed: Nothing.
What others should know: Be sure you consider the height. For example this medium is ideal for most things imo, and I much prefer the lower stance over a high mount. So far I have not needed a high for any gun, but I limit my scopes to 40AO and 44. Example; I have a generic 3-9x40AO Centerpoint (bundled with Crosman/Benjamin guns) that I just measured and the largest part of the obj housing is 2.1", and the cap brings it to ~2.3. Mounted on a generic Crosman break barrel (Titan), with no shims, the dust cap is tight on the receiver so it needs maybe .010" sanded off at that spot. Without the cap there's .060" clearance which is plenty for (most) shimming needs. The cap can be sanded all the way thru if needed so the same clearance would apply. Fyi; scopes, guns and mounts can vary with mfg changes over time etc., but at least you have some info to go on.
Will this work with leapers bug buster scopes?
I have a Daisy Model 131. Do I attached this directly to the dovetail rail or use a base that I attach to dovetail rail 1st? My 2 pc mounts just continue to walk. Is this matte finish? Thank you.
Hi. Will this fir 11mm receiver dovetail rails (HW95)? Thanks
in your case, no. if it was a pcp, co2, or pump action, it would work because there is not that much recoil. I do not own product, but I can tell you than for a magnum gas ram, this will not do.
$25.99$23.99 $79.99$59.99 $19.95$14.95