90-day limited warranty
List Price $30.00 Save $2.01 (6%)
Only 5 left in stock
Want it delivered 09-01-2016?
Order it in the next 21hr and 51min and choose Next Day Air Morning at checkout. Details
Buy and Earn 28 Bullseye Bucks!
other products by Hatsan
Things I liked: Works as advertised. Screws on the end of the barrel vs using set screws. Well made. Fits my Walther Terrus. Makes a significant difference in cocking effort.
Things I would have changed: Advertise that it fits the Walther Terrus.
What others should know: The threads are not an exact match for the Terrus but it tightens up very well.
Things I liked: Aluminum housing with brass insert look good on my Benjamin NP2 without barrel shroud.
Things I would have changed: The brass insert is .010 inch smaller than the bore in the housing. It is retained in position by a single set screw that takes a 2mm hex key, not included. The recoil of the NP2 caused the set screw to back off. Pellets started clipping the insert losing accuracy. I removed the insert so its not an air stripper but it still looks cool. I may try to permanently adhere the insert in the housing if I figure out how to fix it concentric to the rifle bore and what type of glue to use.
What others should know: The NP2 is loud without the shroud.
Things I liked: I installed my Hatsan Air Stripper on my .22 cal Hatsan Supercharger pistol and could not believe how much it tightened up my groups. Aside from the improved accuracy it looks cool on that big hand gun!
Things I would have changed: Put a second or third set-screw to keep brass air scoop in place.
What others should know: If using on a Supercharger, or a similar air gun with significant recoil, be sure set-screw is tight and Loctited in place. Brass air scoop may need occasional adjustment because of recoil.
Once fitted to a Hatsan AT P2 PCP Air Pistol, will the pistol still fit in the case that it comes with?
Adds about 3 inches to length . Can be removed to fit the case.
I believe that the .22 cal. Gamo Coyote, the BSA Buccaneer SE & the BSA Scorpion SE all have the 1/2" X 20 UNF threaded barrels under their removable muzzle brakes. If that is so, then this Hatsan air stripper should fit them too, correct?
I have the BSA Scorpion 1200 SE in .177 caliber . Correct it does fit nicely . Report from the rifle is quieter than without.
Will this fit a Benjamin Trail nP 2 without the shroud on the barrel?
Yes however the brass insert kept coming loose due to recoil. Pellets were clipping the loose insert and losing accuracy. I removed the insert so its no longer a stripper but it still looks cool. The NP2 is loud without the shroud.