Pro Guide spring retainer system for RWS Diana rifles
by B.B. Pelletier
Today, we'll take the next step in evaluating the Air Venturi Pro Guide spring retainer system by testing a stock .22 caliber RWS Diana 48 right out of the box, then installing the Pro Guide system and testing that. Because many of you are interested in working on your own airguns, I decided to turn the disassembly/assembly into a tutorial.
Right out of the box, the first shot from the rifle shooting 14.3-grain Crosman Premiers was 646 f.p.s. I'm telling you that to reassure all of you chronograph hounds that a new air rifle needs a few shots to settle in. Shot No. 2 went 793 f.p.s.--a heck of a lot closer to the anticipated 800 f.p.s. average this model usually gets with .22 Premiers. I shot a dozen times to let the gun settle down, then a string of 10 after that measured an average of 797 f.p.s. - right in the expected range of 790 to 810 f.p.s., depending on the individual rifle. That works out to 20.17 foot-pounds with this loose-fitting pellet.
Now, it's time to install the Pro Guide system. The rifle's action was removed from the stock by loosening the front triggerguard screw and the one forearm screw. Then, the action was disassembled while the gun was held in a B-Square mainspring compressor. Don't look for one on this website; they don't carry it any longer, but you can make one for under $20. The two-part plans are located here. You absolutely have to use a compressor with this gun.
Once the action's out of the stock, the sidelever must be removed. It's held on by two pins, each secured with a circlip on the underside. Remover the smaller pin first and the larger hinge pin last. Look for three washers on the hinge pin: one under the head of the pin and one on either side of the pin bushing.
When the sidelever is off, fold the linkage rod down along the barrel of the rifle, so the action will fit into the mainspring compressor.
Secure the rifle in a mainspring compressor and put some tension on the black plastic end cap. There's a flat shelf conveniently located on the cap. The next picture shows this flat shelf clearly.
First, drift the rear pin all the way out, then drift out the front pin. I'm not sure the order matters anymore with the T05 trigger unit; but, since it was critical with the T01 trigger, all airgunsmiths learned to do it in that order. These two pins are all that hold the trigger unit, which is sheathed by the end cap, in the rifle.
I removed the piston so I could show you some things, but you don't need to remove it (it simply slides out). Once the factory mainspring and rear spring guide have been removed, the Pro Guide system can be installed.
Next time, I'll describe the assembly of the 48, including a couple pointers that'll save you some time and heartache. I'll also report on the velocity of the gun with the Pro Guide unit installed. Please note, if I forget to mention it in the next report, that absolutely NO tuning was performed on this rifle. If I hadn't wanted to show those pictures of the piston, there would have been no reason to remove it from the gun.