Skenco NewBoy Senior .22 Cal, 28.6 Grains, Domed, 100ct

nothing

everything

Horrible group from my .22 Gauntlet

Heavy pellet, has a solid impact zone.

I am shooting a Benjamin trail NP2, and when sighted in for my normal 18 grain round this pellet has a two to three inch drop at 22 yards.

Well formed. No defects noted. Grouped very well. Under a inch.

Nothing.

Shot from a Gen I Mrod, at 30yrds.
These things are BIG! Need a single shot tray.

There a larger long pellet as long as they were seated right shot very good and consistent

Little bit larger skirt

Fit very loose in condor ss had to push them into breech with something if not when bolt closed I would hear them sliding back and forth

Its clean ammo

The weight was off quite abit . I had to weigh them to get them to shoot tight.

excellent knock down power and accurate!

more per tin

great for hunting the accuracy is unbelievable and the energy on impact is amazing!

It had a good screw on lid.

I would make sure the newboy pellets will chamber without force.

If your looking for a heavy pellet this one may do the job. The groups at 30 yards were 1.5 to 2.25. Not my kind of group size.

Skenco quality, clean, nice fit. I dont need 500 of these, Theres not 500 Possums and Coons round here. Glad i aint gotta buy 500. 20+ lb vermin 20yrds & under, Thumbed sized hole after 20 shots indoors at 17yrds low light, Peep sites, kinda like at Barn and a quick humane dispatch. Reasonbly quite around Horses in barn. Much more quite than an 18g Sniper Mag which may puncture tin roof after goin threw a 8+lb vermin in the rafters. Which the 18g already did w/ Tuned 150 Model Hatsan Spring. All my stuff makes 30fpe, in that range it stops them dead in there tracks w/ 1 good shot.

Direct quote from Hatsan USA support team, after i asked about shooting 25g-28g stuff threw my Hat 135 Vortex in .22.....BigWoodHat...You should have no problems shooting the heavier .22cal pellets, as long as they form a good seal in the barrel. Both the .22 and .25 caliber 135 utilize the same powerplant with the same diameter transfer port opening...... Askem yourself, i got this answer back in 3 hours via..email. I own a Tuned 150 Spring in .22 a 155 in .25 Vortex and two 135' one in .22 one in .25, both Vortex. Skenco Works well in all.

I like the size and weight.

Perhaps make them a little shorter and maybe a tin container.

Unfortunately I wasn't able to use these because they would not fit the magazine of my Hatsan AT44-10 QE Long .22 cal. I am sure these are good pellets but they just didn't work for me. I am only giving a low rating because I wasn't able to use them. I am sure they are good pellets for those who can use them. So don't let my low rating stop you from purchasing them. However think twice before buying them if you own a Hatsan AT44-10 QE .22 because they are too long.

I wanted these pellets to work, however they did not fit into my Hatsan AT44-10 QE Long magazine. They are too long. I am sure they will work if you load them one by one but who wants to do that?

Make them a little shorter. They are approximately 11 mm long. Perhaps put in a metal container.

For those who have a Hatsan AT44 with a magazine, you might not want to purchase these. They did not fit into my magazine, they were too long. I gave low rating only because I wasn't able to use them. I am sure these are good pellets, just aren't good for my Hatsan that's all.