Adjustable Grip for Alfa Proj PCP Pistol

This is a must for the right handed shooter, it improved my accuracy substantially, no one should use the ambidextrous when the righthanded is available.

the grips look great but they are going to be small for anyone with a hand bigger then 100mm

the packaging has created a problem with the grips finish so better packaging

so the grips were not dry when that were put in the plastic bags and sealed up and everywhere the plastic stuck to the bag it is now shiny and a little sticky not good at all seeing that i waited for ever for them
they appear to be oiled with and unknown product
a little water was tried to remove the areas did touch it, next some Break Free again no help, next was rubbing alcohol and that didn't work, so to the acetone and that will clean off the shiny areas but not without some rubbing
so waited for ever factory screws up the packaging and now i have to waste my time cleaning up the mess and everyone else that was waiting for these will also or the one's on PA's shelf i would happily take a discount on new purchases good luck PA cleaning these up

Minimal work required to achieve proper fit

They should come on the pistol as original equipment

Spend they money, these grips are the right for!

These grips a very comfortable and they help a lot with consistant shot grouping.

I wish they could be adjusted vertically allowing you to change your wrist position so that the gun held more like a free pistol.

They are worth the investment if you are looking for real tight groups.

Easy to install - but don't tighten the ring much or it will strip out the inner sections of wood that it grips.

I take a large glove on most gloves. This is a short grip and the bottom shelf will be too tight into the outside of your palm. Plan on doing a bit of work on the shelf. I had to thin it down to about the top of the holding screws. It is a bit wide in the front to back dimension and you may have to work on that.

The addition of these grips turn a good gun with good grips into a great gun with great grips. Nice quality wood with good adjustability. Very easy to change.

Nothing

If you like the Alfa Proj stock then you will love it with these grips.

Turns the Alfa into a serious competition gun by fitting your hand better and having a palm shelf for the extra support. Incredibly easy to swap out with the ambi grip. Just loosen a nut that fits over the air chamber in the grip, and pull the grip apart in to it's 2 pieces. Can be swapped in less than a minute.

Add the ability to adjust the angle of the palm shelf as well as the height. Make it in different sizes as well as left-hand. This is the only area where it might not be best for you, depending on your hand size. My right hand is 7 1/4" long from the base of my palm to the tip of my middle finger, and 3" wide across my second set of knuckles.

If you want the Alfa to be the best it can be, you've got to have this grip. Please see my full review of the Alfa on it's info page. Good Luck, See Ya Shootin".