AirForce Scuba Tank Adapter, DIN Connector, Steel Hose

Device worked fine, gauge clearly visible. No surprises

Dynamics and linear design allow me to carry my 3 cu. ft. scuba accessory tank in my shooting box to fill my avenger between relays. The treading was perfectly cut, the bleed perfectly seals. and the quick connect functions securly.

Nothing, it does exactly as advertised.

Be sure to get a male/male adapter when you purchase.

Simply put - its well made and it works.

the air hose does move air to the airgun cylinder

however when connecting to the DIN valve the gauge ends up on the under side of the cylinder and is unreadable.

Ease of use. Good build quality.

Increase the diameter of the gauge. Allow the gauge to be turned away from tank.

This fill whip works great, just a tad difficult to see. On my valve the gauge ends up pointing towards the tank.

Exactly what I was looking for. Needed something to go from scuba tank to a Marauder. This one is a lot cheaper than the one marked for the Maruader. Works like a charm.

The bleed off valve seems a little cheap, but it does work just fine.

Be sure the bleed valve is closed tightly before you start to charge the cylinder, otherwise you will blow air.

Small compact, fits in my shooting bag easily. After pumping using a Hill MK3 for a month, which by the way is a great little pump. The DIN AirForce Tank adapter with the gauge, which matched the 2nd Gen Marauder Gauge on PSI, is a great addition to any shooting bag. Some folks don't like the gauge position or the short hose. With my set up I simply put my Marauder on its UGT bipod 7.5" SWAT/combat version, and the 3500 PSI steel DIN valve scuba tank on it's side and we have a perfect match. By the tank being laid down I don't have to worry about it tipping over and then I can simple rotate is so the AirForce gauge is easy to read and hookem up. Fill em slow...

not much. I like the small compact nature of the adapter and gauge and the short hose. Fits well in my shooting bag and does not take up much room. Somebody said it comes with a $100 bill folded up in the DIN opening...mine must have fell out during shipping...oh well.

OPEN the source valves slowly, allow all cylinders to equalize slowly. That's just good advise coming from an old retired scuba instructor who has been around High Pressure air vessels for a long time. Open slow.....and nothing will blow.......Happy shooting!

Suitable for m-rod, without a hitch

Increase the length of the steel hose , at least by half a foot.

Your can purchase it , if the length is increased, or else , you will easily get irritated , when ever you use them.

very easy to install to scuba tank

I have a muzzle break on my Disco and the outer covering on the break has carbon fiber wrapped around it. Every time I connect or disconnect the hose, it scratches the carbon fiber. Right now I have completely worn off the carbon fiber closes to the fill port on the gun. Its a small area and you can't see it until you turn the gun upside down

Its going to scratch your muzzle break if you have one

Works well easy to use Using on benjamin maurder

Longer hose