Beeman Scope Stop

For a Nitro Piston, it was like Crosman had this stop made for them. The stop pin taps snuggly into receiver. As far as I can see, this stop is on my Fury for the life of the rifle.

Ok, this stop is just crazy HUGE! I bought it to back up a Williams sight. Luckily, the Air gun gods let me catch the elevation just right before the aperture hit the top of the stop. I could not go any deeper with out sanding down the stop - one reviewer did exactly that. They should make a more squat version like my vintage Beeman stops from the '90s that are much better machined and out of the way.

It works, but for peep sight users, if you run out of space to lower it, you have decisions to make. If you jack up the sight, then the stop is a non issue.

Seems well constructed.Clamped securely to my rifle and the stop pin engaged the detent in the receiver as expected.

the overall height was a few thousandths too tall in respect to my low rings.A few seconds on a disc grinder and a touch of Krylon yielded a perfect modification.

I have only fired 50 or so pellets since installation but,I a confident this device will bolster my scope mounts quite adequetly.

this baby works like a champ. I bought a BKL adjustable mount for my Bushnell scope mounted on a Beeman R9. The mount walked backwards. So I got this scope stop. No more problem. there were no threads on my stop pin so had to use a punch to drive it down to receiver.

This works with modifications to prevent scope slippage on my HW90 .25 cal. I had to drill and tap the stop pin hole to screw in a grub screw that fit the large shallow machined hole in the receiver. Metric M6-1.0x12mm grub screw from Lowes-Everbuilt 579 667, then ground down the "tapered cup" on the screw to provide a squared off end that fit the receiver. Or on my RX2 I used a Sun Optics SM7005 recoil block, flip the pin and install with blue locktite on ALL mating surfaces and screws. I've used both and they work equally well...no slippage.

You would think Beeman would provide a stop pin that fits the receiver of their rifles, not the tiny pin that galls the receiver then forces you to do modifications.

I had to use ahead of the stop a dovetail to weaver UTG TO6 droop compensation mount mounted backwards to compensate for the "upward droop" of the HW90 barrel to breech misalignment. My RX2 did not require any compensation so I used a Barska 11mm to Weaver adapter. Both adapters provided enough clearance for the UTG 50mm 6x24 1" scopes used on these rifles.

Once locked down it aint moving.

Using on a Hat 150 Magnum Springer. I had to grind a bit off the top using w/ Peeps sites cause it was taller than i expected. No droop on this Hatsan, rear Diopter sits low on my 150 works fine on Webley Spector where rear Diopter sits higher.

Its made very well. It works.

nothing. maybe a lil cheaper price.

It works great.. i mounted it behind the front scope mount to get better eye relief. iv put at least a 1000 shots through it and its still holding like a vise..

Works as intended!

Nothing!

A well made necessity for certain air guns!

This is the best for a Dove tail Rifles.

Nothing

I recommend it to any one for his gun and has strong recoil in his Rifle.

One of the best Scope stops in the Market. It stay firm on the Dovetail.

None

Do not look any father buy it.

Eliminated any further scope slippage Worked as described.

Nothing that I can think of