Air Venturi Airgun Regulator, Fits Reviews

Good replacement part, as advertised

Slow getting order, a lot of products back ordered

Fast service and a fantastic product.

Install a better air gauge

The air pressure is not correct on this product. However, it is close probably within 200-400 psi.

It was very easy to replace the regulator that I broke foolishly. I have a few carbon fiber tanks and my Air venturi is the only one that you must use a different port while charging up the tank. If you try to fill the tank using the output port instead of the intake port you will eventually destroy the regulator. The warnings are all over the place. It's my fault but it was very easy to fix with this OEM replacement port.

Clearer instructions on what to expect when removing the old one and installing the replacement. If it's really tight you may think it's seized up or your doing something wrong. Your not. It is really as simple as unscrewing the old one and screwing in the new one the new one. You need to have the bottle extremely stabilized to get a good grip. I strapped mine to a deck post using a rubber strap to get the first turn started. It was very tight. But No tape or sealant needed. Hand tightening is sufficient. Could be a little less expensive. The bottle cost 300$ and this part cost 100$.

The warnings on how easy it is to ruin your regulator are accurate and not overkill. It won't take long to ruin it if you try to fill your tank incorrectly but you can fix it. so it's not a total waste.

Seems to work pretty good , it's the only game in town to use a paintball size tank for pcp pellet guns .

I have three reg. and all three are set at 2600 - 2700 psi . I wish they could be tweaked up to 3000 psi so I could get more shots per top off .

Is excellent...works very good. Is what I expect.

Nothing.

I do not know.

it worked

make it so you can use other fill stations not air venturi only or at least state that others wont fit

I bought this thinking it would work with my Benjamin fill station but it wont so I had to buy air venture fill station because the pin that opens valve wont reach with the Benjamin. i would buy elsewhere if you got a Benjamin you can get no name regulators online that will work with Benjamin that have 2900 psi output

Easy to assemble

Only has to be put on hand tight. If you tighten it too much you may tear the seal.

Small size and easy to use

Nothing

I'm going to give it only 2 stars since I bought 2 of them and they both had the same problem.. They would not go beyond 2400ish psi so I had to break out the old pump to top the guns off.

Easy to install and works well.

Nothing

I bought a 4500psi paintball tank off of Craigslist and couldn't figure out why it wouldn't work with my Mrod. Stacey told me that paintball tanks are regulated to 900psi so I replaced it with the Air Venturi and it works like a charm. Thanks Stacey for all of the help and info.

EASY TO USE

I must have gotten a bad one,will not fill my 3000 psi
rifle past 2400psi,the other one I ordered fills the rifle to 3000psi.