Mag, .25 Cal, 9-Shot, Fits Nova, BT65SB & AT44PA Rifles + Hatsan AT-P1 Pistol

Fits my gun - 25 cal correct.

The castings they used for some of these allowed the teeth to get offset, for the mag-cycling function. I would find myself unable to cycle the bolt - binding. I ported and polished the mag, that didn't fix it. I set my sights on the gun, tore it down, to assure it wasn't my equipment. Finally I laid a straight edge across the teeth, and sure enough they were completely out of parallel. I filed all the offset teeth and finally the mags would cycle. I hope you read this before you buy, or come here searching for answers and find your solution! I shouldn't have had to do all that to get it to work, properly, but I always buy OEM. Lesson learned.

Bad, bad quality issues. Will take slight modifications to your magazine to work in your particular rifle.

Multi shot magazine, it’s fantastic how far along air gun technology has come. The Hassan rotary magazine is so much easier and user friendly than the other brands.

Wouldn’t change anything about it, really like the design.

It’s good to have a few of these on hand and pre loaded, to swap out on the fly. Make your shooting experience much more efficient and fun.

Well built, and sturdy. Not cheaply made like some of the plastic ones.

Only think I can think of is to maybe hold more ammo.....

Customer service was great! I got a couple of faulty ones of the 3 I ordered and new ones were immediately sent out to me

Its Hatsan hey its all made in China its hit or miss

Bullboss is highly accurate with barracuda 30.86 grains

Easy to load and not too expensive.

More capacity for ammunition.

Not all pellets are the same and some dont fit as well as others.

I like good quality

Fits my Hatsan Bullboss correctly.

Nothing

Nothing

I really like the magazine system on my Bullboss compared to the other style. I haven't had any problems till I recently bought two new mags. One of them has a lot of machining marks on it and doesn't turn when cocked sometimes. Any ideas for a fix ??

Better quality control...

This magazine functions well with the rifle. I like that its a metal magazine.

I think the biggest draw back to this magazine is its length. I would make it .125" longer, this would allow for longer ammunition to fit. I just don't like this limit issue. The quality control needs to be held at a higher standard. The magazine should not have burrs that will damage my pellets.

Watch for burrs, they aren't too bad to remove but I the customer shouldn't be doing this. Careful with the longer pellets.

They appeared to be well made and fit the air rifle perfectly. I could see no difference from the one shipped with the air rifle.

I see no reason to change anything.

They appear, function, and fit like the one's that came with the air rifle.