Gamo Airgun Bipod, Barrel Clamp, 11-31mm Barrel Diameter

It fits thicker, moderated break barrels. That's why I bought it.

Everything.

Piece of junk! There is no way to truly tighten the ring around the barrel, it slides like on ice. I added an additional screw on top of the ring (where there is a threaded slot for it) to more surely secure it. After about five shots the bipod unlatched itself and fell off.
Just don't buy it!
On top of that the break barrel air rifle finicky harmonics will not do well with something attached to the barrel. Buy a rifle rest in a form of a sandbag. Your groups will tighten.

WELL MADE FOR THE PRICE

WAY,WAY,WAY,TO SHORT,USELESS

DO NOT BUY THIS

It works on my Gamo Air gun and his a decent grip

I would like for it to have some extension. Height wise, what you see is what you get. Also the legs are a little loose

If you just need a barrel clamp for you Gamo air gun this is about all I have found. The unit does work but the quality is lacking. On an up note, I doubt you will ever break this

Has two weaver mounts not shown in illustration. I mounted a laser on one side and a flashlight on the other.

The mount is way to wide I've never personally seen an air rifle or any rifle for that matter with a barrel that size. Ditch the realese tab it detaches after every shot. I tried everything I could without "modifying" it but nothin would keep it on my .22 Gamo whisper nor my .177 big cat 1200. Every time I would take a couple shots the bipod would drop to the floor. Also the pin on the bio

I really like these bipod a bit they're just plain useless. I wouldn't recommend these to any one I purchased three and none of them were any good. Also from sliding back on the barrel when I got it to atleast stay on my rifle, it damaged my barrel leaving an ugly groove.

Not very impressed...Legs are too short!

Extend the legs to a normal height of other bi-pod's on the market!

Very loose fitting seems one has to constantly adjust it...Sorry, I do not recommend it!

I was thrilled to finally find a barrel-mounted bipod for my Gamo Whisper Fusion IGT .177 Cal. Air Rifle. I found it next to impossible to find one large enough to fit the bull barrel. The bipod is well constructed and I appreciated the non-slip pads at the top and bottom of the bipod that help to hold the bipod in place not to mention protect the barrel from surface damage.

The bipod has VERY LITTLE center height adjustment. I would SO MUCH appreciate adjustable extensions, hope that Gamo comes up with 'adapters', and would VERY MUCH appreciate being contacted if they do. The user can unscrew/screw in the aluminum shafts the rubber feet are installed on to raise/lower the center height of the bipod, but only by about 1".

The photo does not show the two slotted accessory block 'ears' on the top or the additional top fitting block that come with the bipod.

I contacted Gamo USA directly and they do have the laser and flashlight for the bipod, but I was told that one needs to contact them directly to order them. The laser is the TWLS650 and the flashlight is the TWLUM80.

I was also told that a mounted flashlight and laser would interfere with my scope.

easy setup

better instructions

no I don't think it's worth 30 bucks. not a bad purchase Though.

I like that it is solid and built tough

I would liked to have longer extending legs it just really short and not all that great for prone shooting better on table top

the spacer for the top is to thick I had to spend some time with a dremmel to get it to the right size cause with out the top spacer the bipod won't stay put, so after that my only beef is I wish it had the longer extending legs like the utg tiger claw, but because gamo has the giant shroud for the whisper pro it is the only clamp on bipod made for it

Just what I have been looking for!

Nothing

Not at this time.