Refurbished Air Venturi EC-3000 EVO Compressor by Hill

Experience the EVOlution of airgun filling with the Hill EC3000 EVO Air Compressor. The EC3000 EVO is dialed in for high performance and built in the United Kingdom from top to bottom. Each component from the tubular metal frame down to the electronic circuit board is designed and manufactured in the UK to ensure reliable accuracy with each fill. 

Several enhancements have been made to increase its efficiency over other units. One such enhancement is the automatic air pressure purge system that strategically evacuates air during a cooling cycle, a pause in the fill, or when it’s done filling. This helps to ease any strain on the motor when it kicks back on against higher pressures and has the side benefit of discharging any moisture from inside the system.

For accuracy and to ensure that the owner doesn’t need to recalibrate during major services, this air compressor comes with a digital pressure sensor and an analog pressure gauge. The EC3000 EVO has a wide range of pressure settings for many different applications and is accurate down to the last PSI. It can be set as low as 755 PSI (50 bar) all the way up to 4,500 PSI (310 bar) making it the ideal compressor to charge a wide variety of air guns.

The digital display and rotary knob are intuitive and give quick access to settings like target pressure and the ability to select units of pressure between BAR, PSI, or MPa. Making it all possible is the newly redesigned software that is designed, built, and tested to Hill’s exact standards to ensure flawless operation. 

This air compressor is capable of filling any PCP gun in your arsenal, and doing so as many times as needed. Explore the latest in airgun filling technology by adding a Hill EC3000 EVO to your workbench. Buy one from Pyramyd Air today.

Refurbished Air Venturi EC-3000 EVO Compressor by Hill

• Max Output Pressure: 4,500 PSI (310 BAR)
• Adjustable Output Pressure
• Automatic Shut-Off
• Automatic Air Pressure Purge
• Runs off of 110V outlet
• Air cooled
• Automated cool down cycle during fills 
• Digital Display
• Output hose with female quick disconnect fitting
• Adjustable Unit Display (BAR, PSI, MPa)
• Displays fill pressure and temperature (in Celcius) during the fill
• Integrated output filter with bleed valve
• Ultra quiet 75dB operation
• Length: 465mm (18.3")
• Height:  385mm (15.16")
• Width: 235mm (9.25")
• Weight: approx. 55 lbs
• Made in England

Please Note: The EC-3000 is recommended for filling PCP guns only. Do not use for breathing air.

Hill Crank Case Oil is in the perfect size bottle for the unit as it takes almost the whole 50ml bottle to fill the crank properly on the initial fill, and should not need topping up for some time.

The Silicone Oil is used all the time by the pump and should need replacing after approximately 50 hours of run time.