Kral Puncher Jumbo Cocking Lever

Seems to be quality i put it on my kral puncher breaker works great

Nothing

No more shiny Chrome! This is far better than the stock arm because the stock arm required to stick your finger between the edge of the magazine and the front of the lever which was almost like a knife blade on the end but now you have this nice handle in your finger just naturally grab it as you pull it back and then the heel of your thumb presses against it if you push it forward. This is a huge increase in the speed of reloading and is a lot less fiddly.

It would have been nice if there was some washers maybe a wave washer or something because there is a little bit of slop. You would think for the money you could get new screw so be careful when you take it apart to replace it that you don't ruin the screw or lose it.

I'm using this on the mega and I like the fact that it becomes invisible compared to the bright Chrome that used to be on there.
Follow up shots are much faster now!
It is also easier to change your power level when the bolt is closed.

I like the biathlon type handle. i got this one to see if it fit my Kral buncher breaker, It fit perfectly. much easier to use then the stock handle. If your looking for a replacement this is the one to get.

the coating is gritty comes off on your hand had to hit it with extra fine steel wool. just enough to remove the loose grit.