Roll over image to zoom in
Lifetime limited warranty
List Price $22.97 Save $5.00 (21%)
Only 1 left in stock
Create an online review and share your thoughts with other customers
Things I liked: do not like this mount. I have contacted UTG on this mount with the issues and they still produce this ring with failure even on pcp guns
Things I would have changed: Change the attachment rail. I HAVE HAD NOTHING BUT FAILURE WITH THESE MOUNTS
What others should know: This mount will crack on the attachment to the rail. Also on Flex weaver rails this mount will cant
Things I liked: I have used these rings on several of my rifles and have always been satisfied. They can't be beat for the price.
Things I would have changed: Nothing.
What others should know: Buy them and you want be disappointed.
Things I liked: The look /finish and the price are pretty good. In the delivered Pack was everything you need , wrench and even a spare srew ...very good the spring behind the locknuts is a nice thing to , you cant lost the fixing screw/nut. a wide base for fixing on the rail is allways an advantage . and looking underneath is not impossible for the iron sights the combination with the barrel droop compensator rail ( 11 mm to weaver/picatinny ) is rock solid on my Diana/rws 48 with 25 J + i lost some scopes from the rail in the past , this one doesnt move ( in combination with the rail adaptor )
Things I would have changed: i got some Problems with mounting my swfa ss 16/42 with it , it does not fit super snug into it , somehow it looks like the inner radius of the half pipes is a bit smaller than the 30 mm scope . i had to open it up a tiny bit for correct seating of the tube. i measured the tube its between ( depending in two calipers ) between 29.95 and 30.05 ...the inner diameter is not so easy to measure without removing the slip tape , but mut first guess is 0.05 mm to small but that is the range for guessing with a standard caliperover all its just taping/laping 5 minutes with 400 core paper and everything fits nice and snug
What others should know: i use this on a diana/rws 48 ( tuned ) with the barrel droop compensator , so far it is rock solid and works well , its almost good enough for seeing through the mounts for your iron sights .i have no doubt that this stops pretty good in combination with the rail the scope from moving on a 25 J + springer .
Create an online review and share your thoughts with other customers. Show Other Reviews
This is the mount I want (no quick release) for my hi-recoil Benji Trail NP2, but the question is: are they tall enough to accomodate the Leapers /UTG 3-12x 44mm objective scope, which I want to order.
It will be close but it should work for you