Hawke 1-Pc Mount, 1" Rings, 9-11mm Rail, Medium, Matte Black

Solid, one piece, affordable mount. This is my second review after mounting this on a Diana 430L and having no issues and great accuracy, I decided to try it on my Weihrauch HW97 K. I was concerned that it wouldn't fit in the receiver grooves of the Weihrauch because the mount has slightly roumded edge but it came and it just licked right it there and I had to give it the nod of approval. Did not need to shim the scope for droop for the Hw97. Took it out back and had it sighted and hitting the same spot on a rotting pumpkin in minutes.

Was worried about fit because mounting edges are slightly rounded. Worked on my Weihrauch HW97 K which has small, tight and precise machined 11mm mounting rail.

Not sure who needs to hear this but, I saw some negative reviews that are probably user error. I have both a 32mm and a 40mm objective scope on two separate rifles and they both are solidly mounted with plenty or space and shooting dimed sized groups or less.

Never used this! it would not work with the Hawke Airmax 3-9x40.. It would be a fine fit for a scope with more mounting space I suppose. Seems well built! but IMO not worth the extra $$.. Buy the UTG! Its a great mount..

IMO it should fit "all" Hawke scopes.. The Airmax requires a 3.75" Max length mount & this one is a 4".. I should have measured! but you would figure..??

Measure before you buy!

This mount is absolutely garbage. I bought to mount a Hawke 3-9 air rifle scope, the mount did not fit the scope well and 3 of the screws stripped in the mount while using a high end torque wrench to the exact specifications and slowly and evenly tightening down. This mount is a cheap piece of junk. Do not buy!

Make it higher quality.

Do not buy.

I recently purchased a TX200 by Air Arms and this mount was the perfect mate..very pleased with it...

Absolutely nothing....

It keeps the scope close to the barrel so that there's not so much hold under for up close shots...

I recently purchased a TX200 by Air Arms and this mount was the perfect mate..very pleased with it...

Absolutely nothing....

It keeps the scope close to the barrel so that there's not so much hold under for up close shots...

This was a good solid mount for my sons new Diana 430L. I stuck an old Simmons 8 point 3-9x40 scope in the mount that sat on top my my 30.06 for 20 years. It no longer zooms, but after shimming the scope at the rear of the mount with a business card I am hitting dime sized groups and smaller at 3x power @ 25yds. I was able to put 50 crosman hollow point pellets within in a hole the size of a quarter at 25 yards. I would say point of aim is not going anywhere.

None

A droop mount would be a better more solid way to compensate for elevation, but this was cheaper and it was an old scope and it worked.

Strong mount marketed by a good company, Hawke optics. Unfortunatly, that's about it.

First off this mount is "Medium " height but is a good 5mm too low to mount a UTG True Hunter 40mm objective scope, nowhere near high enough even without the objective lens cover. 2nd thing is the recoil stop pin is a sharp, hardened point which will bore into the top of your reciever, no good. I would avoid this mount totally unless mounting a 32mm objective scope and you don't mind digging a pointed screw into the reciever of your air rifle.