UTG New Gen 80mm Add-On SWAT Wheel, For AccuShot SWAT Scopes

Thank you so much for the input. For some reason I was not informed of this comment. So did that end up working for you?

Noticed the lateral movement on the wheel a couple of days ago when trying to mount it. It is physically impossible to solidly mount any two circular parts into each other with two mounting connections at 180°. I know that at 80yrs, I am cranky and notice sloppy engineering more, but I have years of training in that field and it just comes to me. I am going to add two new holes for tapping 4-40 set screws that will give me a screw at each of 120° - like they all should have in the first place if it was engineered correctly. I will start at the present hole that is at approximately the 20 ft mark and make that my '0' hole. Counting over from that hole, I will skip a leg and drill another hole with a #43 drill, which is the proper drill to tap a 4-40nc screw. Removing the rubber inner piece with the wavy inner surface, I will use a punch to lightly make a dimple for the drill to follow. Then Ill tap the inner hole and use the new longer set screws I got today. That will fix the problem