Seneca .356 Cal, 105 Grains, Flat Point, 100ct

These worked reasonably well out of my Bulldog, since the Bulldog is designed for ,357 or .358 this was to be expected.

For my uses, can't think of anything.

In order to make better use in my Bulldog, I've put powdercoat on what I have left and ran them through a .358 sizing die. Haven't had a chance to shoot these modded bullets yet so not sure if this helps or hurts.

I was surprised how well they worked through my Benjamin Bulldog considering they are really undersize for that rifle. At 30 yards with iron sights and only resting on a table I had groups under 2 inches. I was getting up around 780 fps off a fresh fill. All that said, the Nosler I bought in the same order were grouping much better, probably from the better fit in the barrel.

Make them in .358 and check consistency, I have a lot with deformed areas at the back from casting.

I went through and powder coated what I had left, then ran them through a .358 sizing die, haven't shot this mod yet.

Accurate and hard hitting

Nothing yet.

Thing to remember is that these are air guns. At 50yrds with 1" groups to me is really good. Even a powder burner is doing well with those group sizes.