Earn 9 Bullseye Bucks
List Price $10.50 Save $1.75 (16%)
Item Code: HN-92665500003 [PY-P-976]
|Suggested for||Small game hunting/plinking|
|Muzzle Energy||27 ft/lbs|
|Muzzle Velocity||902 fps|
|Energy at 25 yds||20 ft/lbs|
|Velocity at 25 yds||778 fps|
|Energy from the initial value at 25 yards||74 % Retained energy at 25 yds (an expression of the 25-yd energy compared to the muzzle energy)|
|Energy at 50 yds||15 ft/lbs|
|Velocity at 50 yds||676 fps|
|Energy from the initial value at 50 yards||56 % Retained energy at 50 yds (an expression of the 50-yd energy compared to the muzzle energy)|
and share your thoughts with other customers
Things I liked: Clean pellet. No black fingers.
Things I would have changed: N/A
What others should know: Shot a 20# Raccoon at about 20 yards. Found the pellet under the skin on the far side with a lung shot. The Benjamin Trail NP2 in 22 cal, dropped her in 20 yards. She tried to climb a fence and fell over, dead. The pellet looked like I hadn't shot it yet. The lead version, in the 22.53 hits the same point of aim. They say that it's a 26 foot/lb gun, so try them out if you have this gun. You can thank me later.
Things I liked: Bought these on 12/29/16. Copper plated for greater penetration. Good muzzle energy out of my Hatsan 85 Sniper and Benji NP2. Accuracy after pellets are looked over.
Things I would have changed: As a HUGE H&N fan, I hate to write this but I ran into this same problem with the Baracuda Powers. Out of every six pellets (I shoot 6 shot groups) one must be thrown out. And I don't mean the skirts are just a little off, they're terribly deformed and bent. I haven't ran into this problem with the standard lead FTT. I have had one bad pellet out of a tin of 500 that I just finished off. Skirt was too small and went too far into breech. My 85 and NP2 both shoot them great. I can achieve the same accuracy out of the FTT Powers, but ONLY if I pick out my pellets. Never had this problem with any H&N products before, and we know that the copper should protect and make the the pellets more resistant to deformation, however, I believe the problem may lie in the copper plating process, or they don't scrutinize these the same as the 5.53 lead pellets for whatever reason.
What others should know: If you just start shooting groups with these, you'll be be very disappointed. Pick your pellets and choose only the ones with a good uniform skirt and you should get good results. I'm going to contact H&N and see if they are aware of the problem. If you buy a tin of 200, you'll probably get 150-170 good pellets.
Things I liked: I like that they have a copper coating which helps prevent lead fouling
Things I would have changed: the cost of course...lol
What others should know: Try them and I'm sure you will like them
Show Other Reviews and share your thoughts with other customers
Will these work in my winchester1400cs ?,mine is chambered inn .22
What's the headsize? 5.53, 5.54 or 5.55?
There is not a standard listed head size on these pellets, they will not be a oversized head size.