H&N Grizzly, .357 Cal, 82 Grains, Hollowpoint, 60ct

price

haven't used them yet

My Bulldog shooting these great out to 40ish yards. They hit hard.

Nothing! I have 4 tins on hand of these.

They don't mushroom but penetrate great! Wish I could get these to shoot this well in my .25 hatsan bt 65 elite. Out of that they get a 1 star. Shows the importance of trying different ammo types, shapes, and weights.

Price was good

In my Shin sung the bullets were very loose. When I shot them they did not shoot hard , which I think may have been due to air blow by around the bullet.

Ok for plinking. but I would check the diameter. y gun is old but other bullets shoot much harder. They may work better in newer rifles

They do not get stuck in the barrel. They are currently available.

I would work on the weight and sizing tolerances.

These were the most in accurate slugs that I have shot out of my RAWS .357. I went from .75 in with the JBS and the NSA slugs at 100 yds. These group around 5 inches consistently. I would not recommend them even for plinking, SHTF possibly.

Nothing

Diameter of the slug needs to be larger. They were so loose in my FX impact. I knew on the first shot they would be terrible .

Anything past 10 yards -forget it. No accuracy whatsoever

The price is good,

These are not as accurate as a heavier pellet in my Benjamin bulldog

they look good

the way they shoot extremely inaccurate they hit all over used them in fx impact hatsan benjamin didn't shoot good in anything

I will not buy again tried them in 2 different caliber

I like the lubricant that almost feels like a liquid Teflon. I got a 950 fps at 2000psi. I still have some of the original and got 900 fps at 2000 psi.

nah-h-h accuracy is excellent and holds wind resistance well. We get 10 to 30 mph winds daily in the mountains. Shooting targets from 30 yds ground lvl and 85 yds from 12 ft tree stand at a 6' railroad tie target. We're shooting .22, .25, and 9mm air rifles

Only thing I would be wishin for is to get 100 rnd tin at the same price...that would make H&N the leader and have a life long loyal customer base.

i shot these from my hatsan hercules bully .357 cal. it feeds easily into the breech and doesn't protrude more than the depth of the magazine. the bullet's weight and shape are very precise. these do have a small torx shape hollow point nose. i weighed a whole tin and i got a low of 81.4 grains and a high of 83.0 grains. i did a 5 shot string after a tank fill up to 250 bar i get 888 fps, 869 fps, 846 fps, 825 fps and 803 fps. i will retest later during the hotter months of the year. the first round after a refill is the only time i can near the advertised 150 fpe for a hercules bully any subsequent shots velocities will be less. i get 1 inch groups at 30 yards on paper. i shot a smooth surface 10 gauge stainless steel sheet metal and im surprised it stopped the h&n grizzly pellets. they hit hard leaving a serious crater and bulged the backside but did not go through. but stacking two shots on the same spot will defeat it

Low cost plinking rounds

Increase the round size to .357